BS EN ISO 294-1:2017 PDF

BS EN ISO 294-1:2017 Referenced Document

ISO 10350-1:2007 Plastics - Acquisition and presentation of comparable single-point data - Part 1: Moulding materials
ISO 10350-2:2011 Plastics - Acquisition and presentation of comparable single-point data - Part 2: Long-fibre-reinforced plastics
ISO 11403-1:2014 Plastics - Acquisition and presentation of comparable multipoint data - Part 1: Mechanical properties
ISO 11403-2:2012 Plastics - Acquisition and presentation of comparable multipoint data - Part 2: Thermal and processing properties
ISO 11403-3:2014 Plastics - Acquisition and presentation of comparable multipoint data - Part 3: Environmental influences on properties
ISO 179-1:2010 Plastics - Determination of Charpy impact properties - Part 1: Non-instrumented impact test
ISO 20753:2008 Plastics - Test specimens
ISO 294-2:1996 Plastics - Injection moulding of test specimens of thermoplastic materials - Part 2: Small tensile bars
ISO 294-3:2002 Plastics - Injection moulding of test specimens of thermoplastics materials - Part 3: Small plates
ISO 294-4:2001 Plastics - Injection moulding of test specimens of thermoplastic materials - Part 4: Determination of moulding shrinkage
ISO 294-5:2011 Plastics - Injection moulding of test specimens of thermoplastic materials - Part 5: Preparation of standard specimens for investigating anisotropy

2017 BS EN ISO 294-1:2017 Plastics. Injection moulding of test specimens of thermoplastic materials. General principles, and moulding of multipurpose and bar test specimens
1997 BS EN ISO 294-1:1997 Plastics - Injection moulding of test specimens of thermoplastic materials - General principles, and moulding of multipurpose and bar test specimens