ISO 294-3:2002
Plastics - Injection moulding of test specimens of thermoplastics materials - Part 3: Small plates
- Standard No.
- ISO 294-3:2002
- Release Date
- 2002
- Published By
- International Organization for Standardization (ISO)
- Status
- Replace By
- ISO 294-3:2002/Amd 1:2006
- Latest
- ISO 294-3:2020
- Scope
- This part of ISO 294 specifies two two-cavity moulds, the type D1 and D2 ISO moulds, for the injection moulding of small plates measuring 60 mm x 60 mm with a preferred thickness of 1 mm (type D1) or 2 mm (type D2), which can be used for a variety of tests. The moulds may additionally be fitted with inserts for studying the effects of weld lines on the mechanical properties (see annex A).
ISO 294-3:2002 Referenced Document
- ISO 294-1:1996 Plastics - Injection moulding of test specimens of thermoplastic materials - Part 1: General principles, and moulding of multipurpose and bar test specimens
- ISO 294-4:2001 Plastics - Injection moulding of test specimens of thermoplastic materials - Part 4: Determination of moulding shrinkage
- ISO 6603-1:2000 Plastics - Determination of puncture impact behaviour of rigid plastics - Part 1: Non-instrumented impact testing
- ISO 6603-2:2000 Plastics - Determination of puncture impact behaviour of rigid plastics - Part 2: Instrumented impact testing
ISO 294-3:2002 history
- 2020 ISO 294-3:2020 Plastics — Injection moulding of test specimens of thermoplastic materials — Part 3: Small plates
- 2006 ISO 294-3:2002/Amd 1:2006 Plastics - Injection moulding of test specimens of thermoplastic materials - Part 3: Small plates; Amendment 1
- 2002 ISO 294-3:2002 Plastics - Injection moulding of test specimens of thermoplastics materials - Part 3: Small plates
- 1996 ISO 294-3:1996 Plastics - Injection moulding of test specimens of thermoplastic materials - Part 3: Small plates
