This European Standard is applicable to manhole tops and gully tops made of composite materials C1, C2 and C3 by using suitably controlled automatic processes that produce a single structure and that do not contain multiple pieces bonded together, with a clear opening up to and including 1000 mm for covering gullies, manholes and inspection chambers for installation within areas subjected to pedestrian and/or vehicular traffic. It is applicable to manhole tops and gully tops for use in- areas which can only be used by pedestrians and pedal cyclists (class A 15); - pedestrian areas and comparable areas, car parks or car parking decks (class B 125); - the area of kerbside channels of roads which, when measured from the kerb edge, extends a maximum of 0,5 m into the carriageway and a maximum of 0,2 m into the pedestrian area (class C 250), and in addition to manhole tops for use in; - carriageways of roads (including pedestrian streets), hard shoulders and parking areas, for all types of road vehicles (class D 400). This European Standard is not applicable in isolation but only in combination with EN 124-1 and gives guidance for combinations of covers/gratings made of composite materials with frames according to EN 124-2, EN 124-3, EN 124-4 or EN 124-6. This document is not applicable to; - manhole tops and gully tops manufactured by means of hand lay-up method; - gratings/covers as part of prefabricated drainage channels according to EN 1433; - floor and roof gullies in buildings which are specified in EN 1253 (all parts); and; - surface boxes.
EN 124-5:2015 Referenced Document
EN 124-1:2015 Gully tops and manhole tops for vehicular and pedestrian areas - Part 1: Definitions@ classification@ general principles of design@ performance requirements and test methods
EN 124-2:2015 Gully tops and manhole tops for vehicular and pedestrian areas - Part 2: Gully tops and manhole tops made of cast iron
EN 124-3:2015 Gully tops and manhole tops for vehicular and pedestrian areas - Part 3: Gully tops and manhole tops made of steel or aluminium alloys
EN 124-4:2015 Gully tops and manhole tops for vehicular and pedestrian areas - Part 4: Gully tops and manhole tops made of steel reinforced concrete
EN 124-6:2015 Gully tops and manhole tops for vehicular and pedestrian areas - Part 6: Gully tops and manhole tops made of polypropylene (PP)@ polyethylene (PE) or unplasticized poly(vinyl chloride) (PVC-U)
EN 1253-1:2015 Gullies for buildings - Part 1: Trapped floor gullies with a depth water seal of at least 50 mm
EN 1253-2:2015 Gullies for buildings - Part 2: Roof drains and floor gullies without trap
EN 1253-3:1999 Gullies for Buildings - Part 3: Quality Control
EN 1253-4:1999 Gullies for Buildings - Part 4: Access Covers
EN 1253-5:2003 Gullies for buildings - Part 5: Gullies with light liquids closure*， 2024-04-20 Update
EN 1433:2002 Drainage channels for vehicular and pedestrian areas - Classification, design and testing requirements, marking and evaluation of conformity*， 2024-04-20 Update
EN 59:1977 Glass Reinforced Plastics: Measurement of Hardness by Means of a Barcol Impressor
EN 124-5:2015 history
2015EN 124-5:2015 Gully tops and manhole tops for vehicular and pedestrian areas - Part 5: Gully tops and manhole tops made of composite materials