This European Standard classifies roof drains and floor gullies without trap for use inside buildings, gives guidance for places of installation and specifies requirements for the construction, design, performance and marking as well as test methods of factory made roof drains and floor gullies without trap (further: floor gullies) for buildings, irrespective of the material for use in drainage systems. Although normally used to convey rainwater and wastewater, these roof drains and floor gullies without trap may convey other wastewater provided there is no risk of damage to components or of injury to health. This European Standard does not apply to trapped floor gullies with a depth of water seal of at least 50 mm as specified in EN 1253-1.
EN 1253-2:2015 Referenced Document
EN 124:1994 Gully Tops and Manhole Tops for Vehicular and Pedestrian Areas - Design Requirements, Type Testing, Marking, Quality Control
EN 1253-1:2015 Gullies for buildings - Part 1: Trapped floor gullies with a depth water seal of at least 50 mm
EN 1253-3:1999 Gullies for Buildings - Part 3: Quality Control
EN 16323:2014 Glossary of wastewater engineering terms
EN 476:2011 General requirements for components used in drains and sewers
EN 1253-2:2015 history
2015EN 1253-2:2015 Gullies for buildings - Part 2: Roof drains and floor gullies without trap
2003EN 1253-2:2003 Gullies for Buildings - Part 2: Test Methods
1998EN 1253-2:1998 Gullies for Buildings - Part 2: Test Methods