This European Standard classifies floor gullies for use inside buildings, gives guidance for places of installation and specifies requirements for the construction, design, performance and marking of factory made gullies for buildings, irrespective of the material, for use in drainage systems requiring a trap with a depth of water seal of at least 50 mm (further: floor gullies). Although normally used to convey domestic wastewater, these floor gullies may convey other wastewater, e. g. industrial wastewater, provided there is no risk of damage to components or of injury to health. This European Standard does not apply to:- linear drainage channels as specified in EN 1433; - gully tops and manhole tops which are specified in EN 124; - roof drains and floor gullies without trap as specified in EN 1253-2.
EN 1253-1:2015 Referenced Document
EN 124:1994 Gully Tops and Manhole Tops for Vehicular and Pedestrian Areas - Design Requirements, Type Testing, Marking, Quality Control
EN 1253-2:2015 Gullies for buildings - Part 2: Roof drains and floor gullies without trap
EN 1253-3:1999 Gullies for Buildings - Part 3: Quality Control
EN 1433:2002 Drainage channels for vehicular and pedestrian areas - Classification, design and testing requirements, marking and evaluation of conformity*， 2024-04-20 Update
EN 16323:2014 Glossary of wastewater engineering terms
EN 476:2011 General requirements for components used in drains and sewers
EN 1253-1:2015 history
2015EN 1253-1:2015 Gullies for buildings - Part 1: Trapped floor gullies with a depth water seal of at least 50 mm
2003EN 1253-1:2003 Gullies for Buildings - Part 1: Requirements
1999EN 1253-1:1999 Gullies for Buildings - Part 1: Requirements