HJ/T 230-2006
Technical requirement for environmental labeling products Energy-saving lamps (English Version)

Standard No.

HJ/T 230-2006

Language

Chinese, Available in English version

Release Date

2006

Published By

Professional Standard - Environmental Protection

Status

Be replaced 2012-10

Replace By

HJ 2518-2012

Latest

HJ 2518-2012

Replace

HJBZ 15.1-1997 HJBZ 15.2-1997

Scope

This standard specifies the definition, basic requirements, technical content and inspection methods of energy-saving lamp environmental labeling products. This standard applies to the following products: Double-ended fluorescent lamps for general lighting: preheated cathode double-ended fluorescent lamps with nominal power in the range of 14 to 65W, using AC power frequency with starters, and preheated cathode double-ended fluorescent lamps operating at high frequency. . Self-ballasted fluorescent lamp for general lighting: rated voltage 220V, frequency 50Hz AC power supply, rated power 60W and below, using screw or bayonet lamp holder, used for general lighting in homes and similar occasions, with integrated start-up control and stable ignition components. of self-ballasted fluorescent lamps. This standard does not apply to shaded self-ballasted fluorescent lamps. Single-ended fluorescent lamp: A single-ended fluorescent lamp with a preheated cathode that is equipped with an internal starting device or uses an external starting device. High-pressure sodium lamp: a high-pressure sodium lamp with a transparent glass bulb used for indoor and outdoor lighting. The power range is 50 to 1000W. It is equipped with the corresponding ballast and trigger and is within the range of 92% to 106% of the rated voltage. Normal starting and ignition.

HJ/T 230-2006 Referenced Document

• GB 19043 Minimum allowable values of energy efficiency and the energy efficiency grades of double-capped fluorescent lamps for general lighting service*， 2013-06-09 Update
• GB 19044-2003 Limited values of energy efficiency and rating criteria of self-ballasted fluorescent lamps for general lighting service
• GB 19573 Limited values of energy efficiency and rating criteria for high-pressure sodium vapour lamps
• GB/T 10682 Double-capped fluorescent lamps-Performance specification *， 2010-08-09 Update
• GB/T 13259 High-pressure sodium vapour lamps—Performance requirements*， 2021-11-26 Update
• GB/T 17262 Single-capped fluorescent lamps.Performance specification*， 2011-06-16 Update

HJ/T 230-2006 history

• 2012 HJ 2518-2012 Technical requirement for environmental labeling products.Lighting source
• 2006 HJ/T 230-2006 Technical requirement for environmental labeling products Energy-saving lamps

HJ/T 230-2006 Technical requirement for environmental labeling products Energy-saving lamps has been changed from HJBZ 15.1-1997 Technical requirements for environmental labeling products Energy-saving fluorescent lamps.

HJ/T 230-2006 Technical requirement for environmental labeling products Energy-saving lamps has been changed from HJBZ 15.2-1997 Technical requirements for environmental labeling products Energy-saving low-mercury double-capped fluorescent tubes.

HJ/T 230-2006 Technical requirement for environmental labeling products Energy-saving lamps was changed to HJ 2518-2012 Technical requirement for environmental labeling products.Lighting source.