ISO 19069-2:2016
Plastics - Polypropylene (PP) moulding and extrusion materials - Part 2: Preparation of test specimens and determination of properties

Standard No.

ISO 19069-2:2016

Release Date

2016

Published By

International Organization for Standardization (ISO)

Latest

ISO 19069-2:2016

ISO 19069-2:2016 Referenced Document

• ASTM D5420-10 Standard Test Method for Impact Resistance of Flat, Rigid Plastic Specimen by Means of a Striker Impacted by a Falling Weight (Gardner Impact)*， 2023-12-24 Update
• IEC 60093:1980 Methods of test for volume resistivity and surface resistivity of solid electrical insulating materials
• IEC 60112:2003 Method for the determination of the proof and the comparative tracking indices of solid insulating materials
• IEC 60243-1:2013 Electric strength of insulating materials - Test methods - Part 1: Tests at power frequencies
• IEC 60250:1969 Recommended methods for the determination of the permittivity and dielectric dissipation factor of electrical insulating materials at power, audio and radio frequencies including meter wavelengths
• IEC 60296:2012 Fluids for electrotechnical applications - Unused mineral insulating oils for transformers and switchgear
• ISO ISO IEC 27001-2013 cor2-2015 technical errata*， 2023-12-24 Update
• ISO 178:2010 Plastics - Determination of flexural properties
• ISO 179-1:2010 Plastics - Determination of Charpy impact properties - Part 1: Non-instrumented impact test
• ISO 179-2:1997 Plastics - Determination of Charpy impact properties - Part 2: Instrumented impact test
• ISO 293:2004 Plastics - Compression moulding of test specimens of thermoplastic materials
• ISO 294-1:1996 Plastics - Injection moulding of test specimens of thermoplastic materials - Part 1: General principles, and moulding of multipurpose and bar test specimens
• ISO 294-3:2002 Plastics - Injection moulding of test specimens of thermoplastics materials - Part 3: Small plates
• ISO 294-4:2001 Plastics - Injection moulding of test specimens of thermoplastic materials - Part 4: Determination of moulding shrinkage
• ISO 527-2:2012 Plastics - Determination of tensile properties - Part 2: Test conditions for moulding and extrusion plastics
• ISO 62:2008 Plastics - Determination of water absorption
• ISO 75-2:2013 Plastics - Determination of temperature of deflection under load - Part 2: Plastics and ebonite
• ISO 899-1:2003 Plastics - Determination of creep behaviour - Part 1: Tensile creep

ISO 19069-2:2016 history

• 2016 ISO 19069-2:2016 Plastics - Polypropylene (PP) moulding and extrusion materials - Part 2: Preparation of test specimens and determination of properties