This standard applies to empty enclosures provided by the enclosure manufacturer before the user installs switchgear and controlgear components (hereinafter referred to as enclosures). This standard specifies the definition, classification, performance and test requirements for enclosures used in low-voltage switchgear and controlgear assemblies, eg in accordance with the IEC 61439 series. Its rated voltage is not more than 1000 V a.c. or 1500 V d.c. and is suitable for indoor or outdoor use. This standard does not apply to housings mentioned in other specific product standards (such as the IEC 60670 series). The complete equipment manufacturer is responsible for the safety requirements of the corresponding product standards.
GB/T 20641-2014 Referenced Document
GB 4208-1993 Degrees of protection provided by enclosure (IP code)
GB 7251.1-2013 Low-voltage switchgear and controlgear assemblies.Part 1:General rules
GB/T 20138-2006 Degrees of protection provided by enclosures for electrical equipment against external mechanical impacts (IK code)
GB/T 2423.17-1993 Basic environmental testing procedures for electric and electronic products. Test Ka:Salt mist
GB/T 2423.2-2008 Environmental testing for electric and electronic products.Part 2:Test methods.Tests B:Dry heat
GB/T 2423.4-2008 Environmental testing for electrical and electronic products - Part 2: Test method Test Db alternating damp heat (12h + 12h cycle)
GB/T 5169.10-2006 Fire hazard testing for electric and electronic products Part 10: Glow/hot-wire based test methods Glow-wire apparatus and common test procedure
GB/T 5169.11-2006 Fire hazard testing for electric and electronic products.Part 11:Glowing/hot-wire based test methods.Glow-wire flammability test method for end-products
GB/T 9341-2008 Plastic.Determination of flexural properties
IEC 60085:2007 Electrical insulation - Thermal evaluation and designation
ISO 179 Plastics — Determination of Charpy impact strength — Technical Corrigendum 1
ISO 4628-3:2003 Paints and varnishes - Evaluation of degradation of coatings; Designation of quantity and size of defects, and of intensity of uniform changes in appearance - Part 3: Assessment of degree of rusting
ISO 4892-2:2006 Plastics - Methods of exposure to laboratory light sources - Part 2: Xenon-arc lamps
GB/T 20641-2014 history
2014GB/T 20641-2014 Empty enclosures for low-voltage switchgear and controlgear assemblies.General requirements
2006GB/T 20641-2006 Empty enclosures for low-voltage switchgear and controlgear assemblies General requirements