SAE AMS2515E-1990 PDF

Scope: This specification establishes the engineering requirements for producing thin coatings of polytetrafluoroethylene (PTFE) resin on parts and the properties of such coatings. Primarily to provide dry lubrication, high heat stability, and corrosion protection on parts which operate at not higher than 275 degrees C (527 degrees F) for limited periods or not higher than 245 degrees C (473 degrees C) for extended periods. This coating may also be used as a release film for molds.

SAE AMS2515E-1990 history

2018 SAE AMS2515H-2018 Polytetrafluoroethylene (PTFE) Resin Coating@ Low Build@ 370 to 400 °C (698 to 752 °F) Fusion
2013 SAE AMS2515G-2013 Polytetrafluoroethylene (PTFE) Resin Coating, Low Build, 370 to 400°C (698 to 752°F) Fusion
2011 SAE AMS2515F-2011 Polytetrafluoroethylene (PTFE) Resin Coating, Low Build, 370 to 400°C (698 to 752°F) Fusion
2003 SAE AMS2515E-2003 Polytetrafluoroethylene (PTFE) Resin Coating Low Build, 370 to 400 °C (698 to 752 °F) Fusion
2003 SAE AMS2515D-2003 Polytetrafluoroethylene (PTFE) Resin Coating Low Build, 370 to 400 °C (698 to 752 °F) Fusion
1990 SAE AMS2515E-1990 Polytetrafluoroethylene (PTFE) Resin Coating Low Build, 370 - 400 Degrees C (698 - 752 Degrees F) Fusion
1983 SAE AMS2515D-1983 Polytetrafluoroethylene Resin Coating Low Build@ 370 Degrees - 400 Degrees C (700 Degrees - 750 Degrees F) Fusion
1974 SAE AMS2515C-1974 Polytetrafluoroethylene Resin Coating Low Build@ 700 Degrees - 750 Degrees F (371 Degrees - 399 Degrees C) Fusion
1965 SAE AMS2515B-1965 Polytetrafluoroethylene Resin Coating Low Build@ 700 - 750 F (371 - 399 C) Fusion
1963 SAE AMS2515A-1963 Polytetrafluoroethylene Resin Coating Low Build@ 700 - 750 F (370 - 400 C) Fusion
1961 SAE AMS2515-1961 Polytetrafluoroethylene Resin Coating 700 - 750 F Fusion