This chapter in GB/T 147536.1 is replaced by the following content. This standard applies to pressure-sensitive electric automatic controllers, the minimum standard specification of which is 60kPa and the maximum standard specification is 4.2MPa, which are installed on, within or attached to household and similar equipment. for use in applications including heating, air conditioning and similar applications. The controlled equipment can be electricity, gas, oil, solid fuel, solar energy, etc. or their combined energy sources. This standard applies to the inherent safety of pressure-sensitive electric automatic controllers, as well as to operating values and operating procedures related to the protection of equipment, and to pressure-sensitive electrical appliances used in household and similar purposes, within or attached to equipment. Testing of automatic controllers. This standard also applies to controllers for appliances within the scope of GB 4706. This standard does not apply to pressure controllers specially designed for industrial use. Throughout this standard the word "equipment" means "apparatus and equipment". This standard applies to electrically or mechanically operated, responsive or controlled electric automatic controls of pressure or vacuum. This standard contains requirements for the electrical characteristics of pressure-sensitive controls and for the mechanical characteristics affecting their intended operation. 11.11.103 to 11.11.106 and 18.101, when they belong to gas and/or oil controllers, will be considered again when ISO/TC 109 and ISO/TC 161 are reviewed and revised. This standard applies to manual controls that are electrically and/or mechanically integrated with pressure-sensitive controls. Typically, these pressure sensitive controls are integral to or mounted on or within the equipment. This standard also covers separately installed controllers. This standard does not cover in-line controllers. This standard applies to controllers with a rated voltage not exceeding 440V DC 1, not exceeding 660V AC, and a rated current not exceeding 63A. This standard does not take into account the response values of the automatic operation of the controller in relation to the method of installation of the controller in the equipment. If the response value is obviously related to the safety of the user or the environment, the applicable response value shall be determined in the corresponding household equipment standard or specified by the manufacturer. This standard applies to pressure-sensitive controllers equipped with electronic components, see Appendix H for requirements.
GB 14536.7-1996 history
2010GB 14536.7-2010 Automatic electrical controls for household and similar use.Particular requirements for automatic electrical pressure sensing controls including mechanical requirements
1996GB 14536.7-1996 Automatic electrical controls for household and similar use.Particular requirements automatic electrical pressure sensing controls including mechanical requirements