ASTM E2113-18
Standard Test Method for Length Change Calibration of Thermomechanical Analyzers
- Standard No.
- ASTM E2113-18
- Release Date
- 2018
- Published By
- American Society for Testing and Materials (ASTM)
- Status
- Replace By
- ASTM E2113-23
- Latest
- ASTM E2113-23
- Scope
- 1.1 This test method describes calibration of the length change (deflection) measurement or thermal expansion of thermomechanical analyzers (TMAs) within the temperature range from –150 °C to 1000 °C using the thermal expansion of a suitable reference material. 1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
ASTM E2113-18 Referenced Document
- ASTM E1142 Standard Terminology Relating to Thermophysical Properties
- ASTM E1363 Standard Test Method for Temperature Calibration of Thermomechanical Analyzers
- ASTM E2161 Standard Terminology Relating to Performance Validation in Thermal Analysis and Rheology*， 2023-08-01 Update
- ASTM E473 Standard Terminology Relating to Thermal Analysis
- ASTM E831 Standard Test Method for Linear Thermal Expansion of Solid Materials by Thermomechanical Analysis*， 2019-04-01 Update
ASTM E2113-18 history
- 2023 ASTM E2113-23 Standard Test Method for Length Change Calibration of Thermomechanical Analyzers
- 2018 ASTM E2113-18 Standard Test Method for Length Change Calibration of Thermomechanical Analyzers
- 2013 ASTM E2113-13 Standard Test Method for Length Change Calibration of Thermomechanical Analyzers
- 2009 ASTM E2113-09 Standard Test Method for Length Change Calibration of Thermomechanical Analyzers
- 2004 ASTM E2113-04 Standard Test Method for Length Change Calibration of Thermomechanical Analyzers
- 2002 ASTM E2113-02 Standard Test Method for Length Change Calibration of Thermomechanical Analyzers
- 2000 ASTM E2113-00 Standard Test Method for Length Change Calibration of Thermomechanical Analyzers
