ASTM E2113-13
Standard Test Method for Length Change Calibration of Thermomechanical Analyzers
- Standard No.
- ASTM E2113-13
- Release Date
- 2013
- Published By
- American Society for Testing and Materials (ASTM)
- Status
- Replace By
- ASTM E2113-18
- Latest
- ASTM E2113-23
- Scope
5.1 Performance verification or calibration is essential to the accurate determination of quantitative dimension change measurements.
5.2 This test method may be used for instrument performance validation, regulatory compliance, research and development and quality assurance purposes.
1.1 This test method describes calibration of the length change (deflection) measurement or thermal expansion of thermomechanical analyzers (TMAs) within the temperature range from –150 to 1000°C using the thermal expansion of a suitable reference material.
1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.3 This test method differs from ISO8201;11359-1 by providing an alternative calibration procedure.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of whoever uses this standard to consult and establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
ASTM E2113-13 Referenced Document
- ASTM E1142 Standard Terminology Relating to Thermophysical Properties
- ASTM E1363 Standard Test Method for Temperature Calibration of Thermomechanical Analyzers
- ASTM E2161 Standard Terminology Relating to Performance Validation in Thermal Analysis and Rheology*， 2023-08-01 Update
- ASTM E473 Standard Terminology Relating to Thermal Analysis
- ASTM E831 Standard Test Method for Linear Thermal Expansion of Solid Materials by Thermomechanical Analysis*， 2019-04-01 Update
- ISO 11359-1 Plastics — Thermomechanical analysis (TMA) — Part 1: General principles*， 2023-02-09 Update
ASTM E2113-13 history
- 2023 ASTM E2113-23 Standard Test Method for Length Change Calibration of Thermomechanical Analyzers
- 2018 ASTM E2113-18 Standard Test Method for Length Change Calibration of Thermomechanical Analyzers
- 2013 ASTM E2113-13 Standard Test Method for Length Change Calibration of Thermomechanical Analyzers
- 2009 ASTM E2113-09 Standard Test Method for Length Change Calibration of Thermomechanical Analyzers
- 2004 ASTM E2113-04 Standard Test Method for Length Change Calibration of Thermomechanical Analyzers
- 2002 ASTM E2113-02 Standard Test Method for Length Change Calibration of Thermomechanical Analyzers
- 2000 ASTM E2113-00 Standard Test Method for Length Change Calibration of Thermomechanical Analyzers
