ISO 104:2015 PDF

Scope: This International Standard specifies preferred boundary dimensions for single-direction and doubledirection thrust bearings with flat back faces. In addition, it gives the minimum bore diameters of housing washers and maximum outside diameters of shaft washers of bearings in dimension series 11, 12, 13, 14, 22, 23 and 24. Guidelines for the extension of this International Standard for single-direction thrust bearings are given in Annex A. NOTE Boundary dimensions for aligning thrust bearings (none flat back faces) and aligning seat washers are given in ISO 20516.[2]

ISO 104:2015 Referenced Document

ISO 15241:2012 Rolling bearings - Symbols for physical quantities
ISO 20516:2007 Rolling bearings - Aligning thrust ball bearings and aligning seat washers - Boundary dimensions
ISO 3:1973 Preferred numbers; Series of preferred numbers
ISO 5593:1997 Rolling bearings - Vocabulary
ISO 582:1995 Rolling bearings - Chamfer dimensions - Maximum values

2015 ISO 104:2015 Rolling bearings - Thrust bearings - Boundary dimensions, general plan
2002 ISO 104:2002 Rolling bearings - Thrust bearings - Boundary dimensions, general plan
1994 ISO 104:1994 Rolling bearings - Thrust bearings - Boundary dimensions, general plan
1979 ISO 104:1979 Rolling bearings; Thrust bearings with flat back faces; Boundary dimensions