ISO 104:2002
Rolling bearings - Thrust bearings - Boundary dimensions, general plan
- Standard No.
- ISO 104:2002
- Release Date
- 2002
- Published By
- International Organization for Standardization (ISO)
- Status
- Replace By
- ISO 104:2015
- Latest
- ISO 104:2015
- Scope
- This International Standard specifies the major boundary dimensions of single-direction and double-direction thrust bearings with flat back faces. In addition, it gives the minimum bore diameters of housing washers and maximum outside diameters of shaft washers of bearings in dimension series 11, 12, 13, 14, 22, 23 and 24. Guidelines for the extension of this International Standard for single-direction thrust bearings are given in annex A.
ISO 104:2002 Referenced Document
- ISO 1132-1:2000 Rolling bearings - Tolerances - Part 1: Terms and definitions
- ISO 15241:2001 Rolling bearings - Symbols for quantities
- ISO 5593:1997 Rolling bearings - Vocabulary
- ISO 582:1995 Rolling bearings - Chamfer dimensions - Maximum values
ISO 104:2002 history
- 2015 ISO 104:2015 Rolling bearings - Thrust bearings - Boundary dimensions, general plan
- 2002 ISO 104:2002 Rolling bearings - Thrust bearings - Boundary dimensions, general plan
- 1994 ISO 104:1994 Rolling bearings - Thrust bearings - Boundary dimensions, general plan
- 1979 ISO 104:1979 Rolling bearings; Thrust bearings with flat back faces; Boundary dimensions
