SAE J429-2014 PDF

Scope: This SAE Standard covers the mechanical and material requirements for inch-series steel bolts, screws, studs, screws for sems , and U-bolts in sizes to 1-1/2 in. inclusive. The term stud as referred to herein applies to a cylindrical rod of moderate length threaded on either one or both ends or throughout its entire length. It does not apply to headed, collared, or similar products which are more closely characterized by requirements shown herein for bolts. The mechanical properties included in Table 1 were compiled at an ambient temperature of approximately 20 °C (68 °F). These properties are valid within a temperature range which depends upon the material

SAE J429-2014 Referenced Document

ASME B18.18-2011 Quality Assurance for Fasteners*， 2024-04-20 Update
ASME B18.2.1-2012 Square, Hex, Heavy Hex, and Askew Head Bolts and Hex, Heavy Hex, Hex Flange, Lobed Head, and Lag Screws (Inch Series)*， 2024-04-20 Update
ASTM E18-14 Standard Test Methods for Rockwell Hardness of Metallic Materials*， 2024-04-20 Update
ASTM F1470-12 Standard Practice for Fastener Sampling for Specified Mechanical Properties and Performance Inspection*， 2024-04-20 Update
ASTM F2328-05 Standard Test Method for Determining Decarburization and Carburization in Hardened and Tempered Threaded Steel Bolts, Screws and Studs*， 2024-04-20 Update
ASTM F606-13 Standard Test Methods for Determining the Mechanical Properties of Externally and Internally Threaded Fasteners, Washers, Direct Tension Indicators, and Rivets*， 2024-04-20 Update
ASTM F788/F788M-08 Standard Specification for Surface Discontinuities of Bolts, Screws, and Studs, Inch and Metric Series*， 2024-04-20 Update
SAE J1268-2010 Hardenability Bands for Carbon and Alloy H Steels
SAE J403-2009 Chemical Compositions of SAE Carbon Steels
SAE J404-2009 Chemical Compositions of SAE Alloy Steels
SAE J409-1995 Product Analysis Permissible Variations from Specified chemical analysis of a Heat or Cast of Steel
SAE J411-1997 Carbon and Alloy Steels
SAE J417-1983 Hardness Tests and Hardness Number Conversions
SAE J995-2012 Mechanical and Material Requirements for Steel Nuts

2014 SAE J429-2014 Mechanical and Material Requirements for Externally Threaded Fasteners
2013 SAE J429-2013 Mechanical and Material Requirements for Externally Threaded Fasteners
2011 SAE J429-2011 Mechanical and Material Requirements for Externally Threaded Fasteners
1999 SAE J429-1999 Mechanical and Material Requirements for Externally Threaded Fasteners
1998 SAE J429-1998 Mechanical and Material Requirements for Externally Threaded Fasteners
1997 SAE J429-1997 MECHANICAL AND QUALITY REQUIREMENTS FOR EXTERNALLY THREADED FASTENERS
1983 SAE J429-1983 Mechanical and Material Requirements for Externally Threaded Fasteners@ Standard
1979 SAE J429K-1979 MECHANICAL AND MATERIAL REQUIREMENTS FOR EXTERNALLY THREADED FASTENERS
1977 SAE J429J-1977 MECHANICAL AND MATERIAL REQUIREMENTS FOR EXTERNALLY THREADED FASTENERS
1977 SAE J429I-1977 MECHANICAL AND MATERIAL REQUIREMENTS FOR EXTERNALLY THREADED FASTENERS
1971 SAE J429F-1971 MECHANICAL AND QUALITY REQUIREMENTS FOR EXTERNALLY THREADED FASTENERS