SAE J429-2011 PDF

Scope: This SAE Standard covers the mechanical and material requirements for inch-series steel bolts, screws, studs, screws for sems, and U-bolts used in automotive and related industries in sizes to 1 1/2 in inclusive. The term "stud" as referred to herein applies to a cylindrical rod of moderate length threaded on either one or both ends or throughout its entire length. It does not apply to headed, collared, or similar products which are more closely characterized by requirements shown herein for bolts. The mechanical properties included in Table 1 were compiled at an ambient temperature of approximately 20 °C and (68 °F). These properties are valid within a temperature range which depends upon the material grade used and thermal and mechanical processing. Other properties such as fatigue behavior, corrosion resistance, impact properties, etc., are beyond the scope of this document and responsibility for ensuring the acceptability of the product for applications where conditions warrant consideration of these other properties must be borne by the end user. of these other properties must be borne by the end user.

SAE J429-2011 history

2014 SAE J429-2014 Mechanical and Material Requirements for Externally Threaded Fasteners
2013 SAE J429-2013 Mechanical and Material Requirements for Externally Threaded Fasteners
2011 SAE J429-2011 Mechanical and Material Requirements for Externally Threaded Fasteners
1999 SAE J429-1999 Mechanical and Material Requirements for Externally Threaded Fasteners
1998 SAE J429-1998 Mechanical and Material Requirements for Externally Threaded Fasteners
1997 SAE J429-1997 MECHANICAL AND QUALITY REQUIREMENTS FOR EXTERNALLY THREADED FASTENERS
1983 SAE J429-1983 Mechanical and Material Requirements for Externally Threaded Fasteners@ Standard
1979 SAE J429K-1979 MECHANICAL AND MATERIAL REQUIREMENTS FOR EXTERNALLY THREADED FASTENERS
1977 SAE J429J-1977 MECHANICAL AND MATERIAL REQUIREMENTS FOR EXTERNALLY THREADED FASTENERS
1977 SAE J429I-1977 MECHANICAL AND MATERIAL REQUIREMENTS FOR EXTERNALLY THREADED FASTENERS
1971 SAE J429F-1971 MECHANICAL AND QUALITY REQUIREMENTS FOR EXTERNALLY THREADED FASTENERS