ASTM D3575-14 PDF

Scope: 5.1 The test procedures provide a standard method of obtaining data for research and development, quality control, acceptance and rejection under specifications, and special purposes.

5.2 The data obtained by these test methods are applicable to the material under conditions of the particular test and are not necessarily the same as obtained in other environments or use conditions.

1.1 These test methods apply to flexible closed cell materials made from olefin polymers or blends of olefin polymers with other polymers as defined in Section 3.

1.2 These test methods cover test procedures only. Product requirements are outlined in Specification D4819.

1.3 Unless specifically stated otherwise, by agreement between the purchaser and supplier, all tests shall be performed in accordance with the test methods specified in this standard.

1.4 The values stated in SI units are to be regarded as the standard.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability or regulatory limitations prior to use.
Note 1—This standard and ISO 7214 address the same subject matter, but differ in technical content.

ASTM D3575-14 Referenced Document

ASTM C177 Standard Test Method for Steady-State Heat Flux Measurements and Thermal Transmission Properties by Means of the Guarded-Hot-Plate Apparatus
ASTM C518 Standard Test Method for Steady-State Thermal Transmission Properties by Means of the Heat Flow Meter Apparatus
ASTM D1056 Standard Specification for Sponge and Expanded Cellular Rubber Products
ASTM D1349 Standard Practice for Rubber-Standard Temperatures for Testing
ASTM D1596 Standard Test Method for Dynamic Shock Cushioning Characteristics of Packaging Material
ASTM D1667 Standard Specification for Flexible Cellular Materials-Vinyl Chloride Polymers and Copolymers (Closed-Cell Foam)
ASTM D2863 Standard Test Method for Measuring the Minimum Oxygen Concentration to Support Candle-like Combustion of Plastics (Oxygen Index)
ASTM D412 Standard Test Methods for Vulcanized Rubber and Thermoplastic Elastomers8212;Tension
ASTM D4819 Standard Specification for Flexible Cellular Materials Made From Polyolefin Plastics
ASTM D624 Standard Test Method for Tear Strength of Conventional Vulcanized Rubber and Thermoplastic Elastomers
ASTM E177 Standard Practice for Use of the Terms Precision and Bias in ASTM Test Methods
ASTM E691 Standard Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method
ASTM F355 Standard Test Method for Shock-Absorbing Properties of Playing Surface Systems and Materials

2020 ASTM D3575-20 Standard Test Methods for Flexible Cellular Materials Made From Olefin Polymers
2014 ASTM D3575-14 Standard Test Methods for Flexible Cellular Materials Made From Olefin Polymers
2008 ASTM D3575-08 Standard Test Methods for Flexible Cellular Materials Made From Olefin Polymers
2000 ASTM D3575-00e1 Standard Test Methods for Flexible Cellular Materials Made From Olefin Polymers
2000 ASTM D3575-00 Standard Test Methods for Flexible Cellular Materials Made From Olefin Polymers
1991 ASTM D3575-91 Standard Test Methods for Flexible Cellular Materials Made From Olefin Polymers