This part of JB/T 9179 specifies the allowances and tolerances for modular steel free forgings that are free forged on a hydraulic press and whose axial end faces need to be flat. This section applies to module forgings whose module thickness is less than or equal to the width, and the end face of the width is less than or equal to the length needs to be flattened.
JB/T 9179.6-2013 Referenced Document
JB/T 9179.1-2013 Machining allowances and tolerances of open die forgings on hydraulic press.Part 1: General requirements
JB/T 9179.2-2013 Machining allowances and tolerances of open die forgings on hydraulic press.Part 2: Round shaft, square shaft and rectangular cross-section
JB/T 9179.6-2013 history
2013JB/T 9179.6-2013 Machining allowances and tolerances of open die forgings on hydraulic press.Part 6: Die block
1999JB/T 9179.6-1999 Machining allowances and tolerances of open forgings on hydraulic press.Die block