This part of JB/T 9179 specifies the allowances and tolerances for steel free forgings of short cylindrical types (including short symmetrical polygonal columns) that are free forged on a hydraulic press and whose axial end faces need to be flattened. This section applies to short cylindrical (including short symmetrical polygonal columns) steel free forgings whose height (length) is greater than or equal to the diameter of the part and less than or equal to 1.5 times the diameter of the part.
JB/T 9179.5-2013 Referenced Document
JB/T 9179.1-2013 Machining allowances and tolerances of open die forgings on hydraulic press.Part 1: General requirements
JB/T 9179.2-2013 Machining allowances and tolerances of open die forgings on hydraulic press.Part 2: Round shaft, square shaft and rectangular cross-section
JB/T 9179.5-2013 history
2013JB/T 9179.5-2013 Machining allowances and tolerances of open die forgings on hydraulic press.Part 5: Short round shaft
1999JB/T 9179.5-1999 Machining allowances and tolerances of open forgings on hydraulic press.Short round shaft