SAE J814-2013
Coolants for Internal Combustion Engines

Standard No.

SAE J814-2013

Release Date

2013

Published By

Society of Automotive Engineers (SAE)

Status

Be replaced 2018-03

Replace By

SAE J814-2018

Latest

SAE J814-2023

Scope

This SAE Information Report is a source of information concerning the basic properties of engine coolants which are satisfactory for use in internal combustion engines. Engine coolant concentrate (antifreeze) must provide adequate corrosion protection, lower the freezing point, and raise the boiling point of the engine coolant. For additional information on engine coolants see ASTM D 3306 and ASTM D 4985. The values presented describe desirable basic properties. The results from laboratory tests are not conclusive, and it should be recognized that the final selection of satisfactory coolants can be proven only after a series of performance tests in vehicles

SAE J814-2013 Referenced Document

• ASTM D1119-05 Standard Test Method for Percent Ash Content of Engine Coolants*， 2024-04-20 Update
• ASTM D1120-11 Standard Test Method for Boiling Point of Engine Coolants*， 2024-04-20 Update
• ASTM D1121-11 Standard Test Method for Reserve Alkalinity of Engine Coolants and Antirusts*， 2024-04-20 Update
• ASTM D1122-13 Standard Test Method for Density or Relative Density of Engine Coolant Concentrates and Engine Coolants By The Hydrometer*， 2024-04-20 Update
• ASTM D1177-12 Standard Test Method for Freezing Point of Aqueous Engine Coolants*， 2024-04-20 Update
• ASTM D1287-11 Standard Test Method for pH of Engine Coolants and Antirusts*， 2024-04-20 Update
• ASTM D1384-05 Standard Test Method for Corrosion Test for Engine Coolants in Glassware*， 2024-04-20 Update
• ASTM D1881-97 Standard Test Method for Foaming Tendencies of Engine Coolants in Glassware
• ASTM D1882-96 Standard Test Method for Effect of Cooling System Chemical Solutions on Organic Finishes for Automotive Vehicles
• ASTM D2570-10 Standard Test Method for Simulated Service Corrosion Testing of Engine Coolants*， 2024-04-20 Update
• ASTM D2809-09 Standard Test Method for Cavitation Corrosion and Erosion-Corrosion Characteristics of Aluminum Pumps With Engine Coolants*， 2024-04-20 Update
• ASTM D2847-07 Standard Practice for Testing Engine Coolants in Car and Light Truck Service*， 2024-04-20 Update
• ASTM D3306-11 Standard Specification for Glycol Base Engine Coolant for Automobile and Light-Duty Service*， 2024-04-20 Update
• ASTM D3321-13 Standard Test Method for Use of the Refractometer for Field Test Determination of the Freezing Point of Aqueous Engine Coolants*， 2024-04-20 Update

SAE J814-2013 history

• 2023 SAE J814-2023 Coolants for Internal Combustion Engines
• 2018 SAE J814-2018 ENGINE COOLANTS
• 2013 SAE J814-2013 Coolants for Internal Combustion Engines
• 2007 SAE J814-2007 Engine Coolants
• 1999 SAE J814-1999 Engine Coolants
• 1996 SAE J814-1996 ENGINE COOLANTS
• 1988 SAE J814-1988 Engine Coolants
• 1978 SAE J814C-1978 ENGINE COOLANTS