SAE J2486-2013 PDF

Scope: This SAE Recommended Practice covers installation and inspection methods for fasteners which are tensioned using Tension Indicating Washers (TIWs) as a means to ensure that adequate tension is developed in mechanically fastened joints. Figure 1 depicts a typical TIW, and Figure 2 depicts a fastener assembly with a TIW before and after tensioning. This document describes practices for the use of TIWs which are typically produced for use with SAE J429 Grade 5 and Grade 8 fasteners or their metric counterparts, although the same principals hold true for bolted joints using other fasteners. Users are advised to contact a manufacturer for advice on use of these

SAE J2486-2013 Referenced Document

ASTM E4-10 Standard Practices for Force Verification of Testing Machines*， 2024-04-20 Update
ASTM F959-13 Standard Specification for Compressible-Washer-Type Direct Tension Indicators for Use with Structural Fasteners*， 2024-04-20 Update
SAE J1701-2013 Torque-Tension Tightening for Inch Series Fasteners
SAE J1701M-1996 Torque-Tension Tightening for Metric Series Fasteners, Information Report
SAE J174-2013 Torque-Tension Test Procedure for Steel Threaded Fasteners Inch Series
SAE J174M-2013 Torque-Tension Test Procedure for Steel Threaded fasteners Metric Series
SAE J429-2011 Mechanical and Material Requirements for Externally Threaded Fasteners