ASTM B306-13
Standard Specification for Copper Drainage Tube (DWV)

Standard No.
ASTM B306-13
Release Date
2013
Published By
American Society for Testing and Materials (ASTM)
Status
Replace By
ASTM B306-20
Latest
ASTM B306-20
Scope

17.1 For the purpose of determining compliance with the specified limits for requirements of the properties listed in the following table, an observed value or a calculated value shall be rounded as indicated in accordance with the rounding method of Practice E29:

Property

Rounded Unit for Observed or
Calculated Value

 

8199;8199;8199;Chemical composition

nearest unit in the last right-hand place of

8199;8199;8199;Hardness

8199;figures of the specified limit

 

 

8199;8199;8199;Tensile strength

nearest ksi (5 MPa)


1.1 This specification establishes the requirements for seamless copper tube (DWV) produced from Copper UNS No. C12200 and intended for sanitary drainage, waste, and vent piping.

Note 1—Fittings used for soldered or brazed connections in drainage, waste, or vent systems are described in ASME Standards B16.23 and B16.29 and CSA Standard B158.1.
Note 2—The assembly of copper drainage, waste, and vent systems by soldering is described in Practice B828.
Note 3—Solders for joining copper drainage, waste, or vent systems are described in Specification B32. The requirement for acceptable fluxes for these systems are described in Specification B813.

1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.