ISO 13588:2012
Non-destructive testing of welds - Ultrasonic testing - Use of automated phased array technology
- Standard No.
- ISO 13588:2012
- Release Date
- 2012
- Published By
- International Organization for Standardization (ISO)
- Status
- Replace By
- ISO 13588:2019
- Latest
- ISO 13588:2019
- Scope
- This International Standard specifies the application of the phased array technology for the semi- or fully automated ultrasonic testing of fusion-welded joints in metallic materials of minimum thickness 6 mm. It applies to full penetration welded joints of simple geometry in plates, pipes, and vessels, where both the weld and parent material are low-alloyed carbon steel. Where material-dependent ultrasonic parameters are specified in this International Standard, they are based on steels having an ultrasonic sound velocity of (5920 ± 50) m/s for longitudinal waves, and (3255 ± 30) m/s for transverse waves. It is necessary to take this fact into account when examining materials with a different velocity. This International Standard provides guidance on the specific capabilities and limitations of phased array technology for the detection, location, sizing and characterization of discontinuities in fusion-welded joints. Phased array technology can be used as a stand-alone technology or in combination with other non-destructive testing (NDT) methods or techniques, for manufacturing inspection, pre-service and for in-service inspection. This International Standard specifies four testing levels, each corresponding to a different probability of detection of imperfections. This International Standard permits assessment of indications for acceptance purposes based on either amplitude (equivalent reflector size) and length or height and length. This International Standard does not include acceptance levels for discontinuities. This International Standard is not applicable: — for coarse-grained metals and austenitic welds; — for automated testing of welds during the production of steel products covered by ISO 10893-8,[3]
ISO 13588:2012 Referenced Document
- EN 1330-4 Non-destructive testing - Terminology - Part 4: Terms used in ultrasonic testing
- EN 16018 Non-destructive testing - Terminology - Terms used in ultrasonic testing with phased arrays*， 2024-04-20 Update
- EN 16392-2 Non-destructive testing - Characterisation and verification of ultrasonic phased array equipment - Part 2: Probes*， 2014-03-01 Update
- EN 473 Non-destructive testing - Qualification and certification of NDT personnel - General principles
- ISO 10863 Non-destructive testing of welds — Ultrasonic testing — Use of time-of-flight diffraction technique (TOFD)*， 2020-05-14 Update
- ISO 17635 Non-destructive testing of welds - General rules for metallic materials*， 2016-12-01 Update
- ISO 17640 Non-destructive testing of welds - Ultrasonic testing - Techniques, testing levels, and assessment*， 2018-09-30 Update
- ISO 9712 Non-destructive testing — Qualification and certification of NDT personnel*， 2021-12-21 Update
ISO 13588:2012 history
- 2019 ISO 13588:2019 Non-destructive testing of welds — Ultrasonic testing — Use of automated phased array technology
- 2012 ISO 13588:2012 Non-destructive testing of welds - Ultrasonic testing - Use of automated phased array technology
