ISO 10350 specifies specific test methods for determining and presenting comparable characteristics for certain basic properties of plastics. In general, each property is defined by a single measurement, but in certain cases a property is characterized by two values obtained under different test conditions or along different material directions. The listed properties are usually recorded by the manufacturer in data sheets. This part of ISO 10350 applies to thermoplastic and thermosetting materials that have reinforcement either by discontinuous fibers with a length before processing of more than 7.5 mm or by continuous fibers (e.g. woven fabrics, continuous mats of single strands or unidirectional plastics). Part 1 of this International Standard specifically addresses unreinforced and filled plastics and plastics with fibers less than 7.5 mm in length.
EN ISO 10350-2:2011 Referenced Document
IEC 60093:1980 Methods of test for volume resistivity and surface resistivity of solid electrical insulating materials
IEC 60112:2003 Method for the determination of the proof and the comparative tracking indices of solid insulating materials
IEC 60243-1:1998 Electrical strength of insulating materials - Test methods - Part 1: Tests at power frequencies
IEC 60250:1969 Recommended methods for the determination of the permittivity and dielectric dissipation factor of electrical insulating materials at power, audio and radio frequencies including meter wavelengths
IEC 60296:2003 Fluids for electrotechnical applications - Unused mineral insulating oils for transformers and switchgear
IEC 60695-11-10:1999 Fire hazard testing - Part 11-10: Test flames; 50 W horizontal and vertical flame test methods
IEC 60695-11-20:1999 Fire hazard testing - Part 11-20: Test flames; 500 W flame test methods
ISO 179-1:2010 Plastics - Determination of Charpy impact properties - Part 1: Non-instrumented impact test
ISO 179-2:1997 Plastics - Determination of Charpy impact properties - Part 2: Instrumented impact test
ISO 291:2008 Plastics - Standard atmospheres for conditioning and testing
ISO 62:2008 Plastics - Determination of water absorption
ISO 75-3:2004 Plastics - Determination of temperature of deflection under load - Part 3: High-strength thermosetting laminates and long-fibre-reinforced plastics
EN ISO 10350-2:2011 history
2020EN ISO 10350-2:2020 Plastics - Acquisition and presentation of comparable single-point data - Part 2: Long-fibre-reinforced plastics (ISO 10350-2:2020)
2011EN ISO 10350-2:2011 Plastics - Acquisition and presentation of comparable single-point data - Part 2: Long-fibre-reinforced plastics
2001EN ISO 10350-2:2001 Plastics - Acquisition and Presentation of Comparable Single-Point DataPart 2: Long-Fibre-Reinforced Plastic ISO 10350-2:2001