ASTM D6535/D6535M-05(2010)e1
Standard Test Method for Determining the Dip Tube Length of a Mechanical Pump Dispenser

Standard No.

ASTM D6535/D6535M-05(2010)e1

Release Date

2005

Published By

American Society for Testing and Materials (ASTM)

Status

Be replaced

Replace By

ASTM D6535/D6535M-18

Latest

ASTM D6535/D6535M-18

Scope

This test method is to be used to determine the length of a dip tube of a mechanical pump dispenser that extends to the bottom-corner of a container.

This test method is to be used to determine the length of a dip tube of a mechanical pump dispenser that extends to the bottom-center of a container.

1.1 This test method covers the determination technique for a dip tube of a mechanical pump dispenser.

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

ASTM D6535/D6535M-05(2010)e1 history

• 2018 ASTM D6535/D6535M-18 Standard Practice for Determining the Dip Tube Length of a Mechanical Pump Dispenser
• 2005 ASTM D6535/D6535M-05(2010)e1 Standard Test Method for Determining the Dip Tube Length of a Mechanical Pump Dispenser
• 2005 ASTM D6535-05 Standard Test Method for Determining the Dip Tube Length of a Mechanical Pump Dispenser
• 2000 ASTM D6535-00 Standard Test Method for Determining the Dip Tube Length of a Mechanical Pump Dispenser