ASTM D6535/D6535M-18 PDF

Scope: 1.1 This practice covers the determination technique for a dip tube of a mechanical pump dispenser. 1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM D6535/D6535M-18 history

2018 ASTM D6535/D6535M-18 Standard Practice for Determining the Dip Tube Length of a Mechanical Pump Dispenser
2005 ASTM D6535/D6535M-05(2010)e1 Standard Test Method for Determining the Dip Tube Length of a Mechanical Pump Dispenser
2005 ASTM D6535-05 Standard Test Method for Determining the Dip Tube Length of a Mechanical Pump Dispenser
2000 ASTM D6535-00 Standard Test Method for Determining the Dip Tube Length of a Mechanical Pump Dispenser