This document !specifies all significant" hazards, hazardous situations and events as listed in Clause 4
which are relevant to stationary and displaceable hand fed single spindle vertical moulding machines (with or
without demountable power feed unit), herein after referred to as "machines", designed to cut solid wood, chip
board, fibreboard, plywood and also these materials if they are covered with plastic laminate or edgings when
they are used as intended and under the conditions foreseen by the manufacturer.
This document does not apply to:
a) machines equipped with outboard bearings;
b) machines equipped with powered movements of front extension table and/or tenoning travelling table;
c) hand held woodworking machines or any adaptation permitting their use in a different mode, i.e. bench
mounting;
d) machines set up on a bench or a table similar to a bench, which are intended to carry out work in a
stationary position, capable of being lifted by one person by hand. The bench can also be an integrated
part of the machine if it consists of hinged legs which can be extended down;
This document is not applicable to hand fed single spindle vertical moulding machines which are
manufactured before the date of its publication as EN.
BS EN 848-1:2007+A1:2009 history
0000 BS EN 848-1:2007+A2:2012(2013)
2007BS EN 848-1:2007+A2:2012 Safety of woodworking machines. One side moulding machines with rotating tool. Single spindle vertical moulding machines
2007BS EN 848-1:2007+A1:2009 Safety of woodworking machines - One side moulding machines with rotating tool - Single spindle vertical moulding machines
2007BS EN 848-1:2007 Safety of woodworking machines - One side moulding machines with rotating tool - Single spindle vertical moulding machines
1999BS EN 848-1:1999 Safety of woodworking machines - One side moulding machines with rotating tool - Single spindle vertical moulding machines