This European Standard specifies the requirements and/or measures to remove the hazards and limit the risk on hand-fed vertical spindle moulding machines, hereinafter referred to as "machines", designed to cut solid wood, chip board, fibreboard, plywood and also these materials where they are covered with plastic laminate or edgings.
This European Standard covers all the hazards relevant to this machine. These hazards are listed in clause 4.
This European Standard does not apply to machines set up on a bench or a table similar to a bench which are intended to carry out work in a stationary position and capable of being lifted by hand by one person.
This European Standard does not apply to hand-held woodworking machines or any adaptation permitting their use in a different mode, i.e. bench mounting and numeric control (NC).
This European Standard is primarily applicable to machines which are manufactured after the date of issue of this standard.
This European Standard does not apply to machines equipped with outboard bearings.
BS EN 848-1:1999 history
0000 BS EN 848-1:2007+A2:2012(2013)
2007BS EN 848-1:2007+A2:2012 Safety of woodworking machines. One side moulding machines with rotating tool. Single spindle vertical moulding machines
2007BS EN 848-1:2007+A1:2009 Safety of woodworking machines - One side moulding machines with rotating tool - Single spindle vertical moulding machines
2007BS EN 848-1:2007 Safety of woodworking machines - One side moulding machines with rotating tool - Single spindle vertical moulding machines
1999BS EN 848-1:1999 Safety of woodworking machines - One side moulding machines with rotating tool - Single spindle vertical moulding machines