DIN EN 60112:2010 PDF

Standard No.: DIN EN 60112:2010
Release Date: 2010
Published By: German Institute for Standardization
Status: Be replaced
Replace By: DIN EN 60112 E:2016
Latest: DIN EN 60112 E:2016
Replace: DIN EN 60112/A1:2009 DIN EN 60112 Berichtigung 2:2004 DIN EN 60112:2003

Scope: This International standard specifies the method of test for the determination of the proof and comparative tracking indices of solid insulating materials on pieces taken from parts of equipment and on plaques of material using alternating voltages. This present amendment introduces a simplification on the topic of test solutions.

DIN EN 60112:2010 Referenced Document

ISO 293:1986 Plastics; Compression moulding test specimens of thermoplastic materials
ISO 294-1:1996 Plastics - Injection moulding of test specimens of thermoplastic materials - Part 1: General principles, and moulding of multipurpose and bar test specimens
ISO 294-3:2002 Plastics - Injection moulding of test specimens of thermoplastics materials - Part 3: Small plates
ISO 295:1991 Plastics; compression moulding of test specimens of thermosetting materials

2016 DIN EN 60112 E:2016 Draft Document - Method for the determination of the proof and the comparative tracking indices of solid insulating materials (IEC 112/369/CD:2016)
2010 DIN EN 60112:2010 Method for the determination of the proof and the comparative tracking indices of solid insulating materials (IEC 60112:2003 + A1:2009); German version EN 60112:2003 + A1:2009
0000 DIN EN 60112/A1:2009
0000 DIN EN 60112 Berichtigung 2:2004
0000 DIN EN 60112:2003