ASTM D2370-98(2002)e1
Standard Test Method for Tensile Properties of Organic Coatings

Standard No.

ASTM D2370-98(2002)e1

Release Date

1998

Published By

American Society for Testing and Materials (ASTM)

Status

Be replaced

Replace By

ASTM D2370-98(2010)

Latest

ASTM D2370-16(2021)

Scope

Tensile properties determined by this method are of value in studying the behavior of coatings subjected to environmental stresses, such as those produced by aging and weathering. (See Refs. (1-10).)

Tensile properties may vary with specimen thickness, method of preparation, gage length, rate of load application, tensile tester response, and type of grips used. Consequently, where precise comparative results are desired, these factors must be carefully controlled.

1.1 This test method covers the determination of the elongation, tensile strength, and stiffness (modulus of elasticity) of organic coatings when tested as free films.

1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific hazard statements are given in Section 7.

ASTM D2370-98(2002)e1 Referenced Document

• ASTM D1005 Standard Test Method for Measurement of Dry-Film Thickness of Organic Coatings Using Micrometers*， 2020-06-01 Update
• ASTM D3980 Standard Practice for Interlaboratory Testing of Paint and Related Materials
• ASTM D4708 Standard Practice for Preparation of Uniform Free Films of Organic Coatings*， 1999-04-19 Update
• ASTM D823 Standard Practices for Producing Films of Uniform Thickness of Paint, Varnish, and Related Products on Test Panels
• ASTM D882 Standard Test Method for Tensile Properties of Thin Plastic Sheeting

ASTM D2370-98(2002)e1 history

• 2021 ASTM D2370-16(2021) Standard Test Method for Tensile Properties of Organic Coatings
• 2016 ASTM D2370-16 Standard Test Method for Tensile Properties of Organic Coatings
• 1998 ASTM D2370-98(2010) Standard Test Method for Tensile Properties of Organic Coatings
• 1998 ASTM D2370-98(2002)e1 Standard Test Method for Tensile Properties of Organic Coatings
• 1998 ASTM D2370-98(2002) Standard Test Method for Tensile Properties of Organic Coatings
• 1998 ASTM D2370-98 Standard Test Method for Tensile Properties of Organic Coatings