ASTM D5019-07a
Standard Specification for Reinforced CSM (Chlorosulfonated Polyethylene) Sheet Used in Single-Ply Roof Membrane

Standard No.

ASTM D5019-07a

Release Date

2007

Published By

American Society for Testing and Materials (ASTM)

Status

Withdraw 2011-05

Latest

ASTM D5019-07a

Scope

1.1 This specification covers reinforced non-vulcanized polymeric sheet made from chlorosulfonated polyethylene (CSM) (see Note 1 ) intended for use as a single-ply roof membrane exposed to the weather. The sheet shall be reinforced with fiber or fabric.

Note 1

The term CSPE for chlorosulfonated polyethylene is commonly used in the roofing industry.

1.1.1 The polymers used in these sheets have thermoplastic characteristics at time of installation. The chlorosulfonated polyethylene will vulcanize in place under ambient conditions.

1.2 The tests and property limits used to characterize these sheets are minimum values.

1.2.1 In-place roof systems design criteria such as fire resistance, field seaming strength, impact/puncture resistance, material compatibility, and uplift resistance, among others, are factors that must be considered, but are beyond the scope of this specification.

1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.4 The following precautionary caveat pertains to the test methods portion only, Section 8, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

ASTM D5019-07a Referenced Document

• ASTM D1004 Standard Test Method for Initial Tear Resistance of Plastic Film and Sheeting
• ASTM D1149 Standard Test Method for Rubber Deterioration-Surface Ozone Cracking in a Chamber
• ASTM D1204 Standard Test Method for Linear Dimensional Changes of Nonrigid Thermoplastic Sheeting or Film at Elevated Temperature
• ASTM D2136 Standard Test Method for Coated Fabrics-Low-Temperature Bend Test
• ASTM D412 Standard Test Methods for Vulcanized Rubber and Thermoplastic Elastomers8212;Tension
• ASTM D413 Standard Test Methods for Rubber Property—Adhesion to Flexible Substrate
• ASTM D471 Standard Test Method for Rubber Property-Effect of Liquids
• ASTM D518 Standard Test Method for Rubber Deterioration-Surface Cracking
• ASTM D751 Standard Test Methods for Coated Fabrics
• ASTM G151 Standard Practice for Exposing Nonmetallic Materials in Accelerated Test Devices that Use Laboratory Light Sources
• ASTM G155 Standard Practice for Operating Xenon Arc Lamp Apparatus for Exposure of Materials*， 2024-04-19 Update

ASTM D5019-07a history

• 2007 ASTM D5019-07a Standard Specification for Reinforced CSM (Chlorosulfonated Polyethylene) Sheet Used in Single-Ply Roof Membrane
• 2007 ASTM D5019-07 Standard Specification for Reinforced CSM (Chlorosulfonated Polyethylene) Sheet Used in Single-Ply Roof Membrane
• 2005 ASTM D5019-05 Standard Specification for Reinforced CSM (Chlorosulfonated Polyethylene) Sheet Used in Single-Ply Roof Membrane
• 1996 ASTM D5019-96e1 Standard Specification for Reinforced Non-Vulcanized Polymeric Sheet Used in Roofing Membrane