DIN EN 754-7:2008 PDF

Scope: This document specifies the tolerances on dimensions and form for aluminium and aluminium alloys cold drawn seamless tubes with an outside diameter (OD) from 3 mm to 350 mm (round tube, see Figure 1) or with a cross section contained within a circumscribing circle (CD) from 8 mm to 300 mm (other than round tube, see Figure 2) supplied in straight lengths. This standard only applies to tube produced by the seamless die/mandrel method of extrusion (and then cold drawn to the final dimensions required). The temper designations used in this part are according to EN 515. This document applies to cold drawn seamless tube for general engineering applications. This document does not apply to: -- cold drawn tube produced by the porthole/bridge method (EN 754-8), -- tubes delivered in coils (EN 13958), -- coiled tubes cut to lenath (EN 13958).

DIN EN 754-7:2008 history

2016 DIN EN 754-7:2016-10 Aluminium and aluminium alloys - Cold drawn rod/bar and tube - Part 7: Seamless tubes, tolerances on dimensions and form; German version EN 754-7:2016
2016 DIN EN 754-7:2016 Aluminium and aluminium alloys - Cold drawn rod/bar and tube - Part 7: Seamless tubes, tolerances on dimensions and form; German version EN 754-7:2016
2008 DIN EN 754-7:2008 Aluminium and aluminium alloys - Cold drawn rod/bar and tube - Part 7: Seamless tubes, tolerances on dimensions and form; English version of DIN EN 754-7:2008-06
1998 DIN EN 754-7:1998 Aluminium and aluminium alloys - Cold drawn rod/bar and tube - Part 7: Seamless tubes, tolerances on dimensions and form; German version EN 754-7:1998