DIN EN 754-7:1998
Aluminium and aluminium alloys - Cold drawn rod/bar and tube - Part 7: Seamless tubes, tolerances on dimensions and form; German version EN 754-7:1998

Standard No.

DIN EN 754-7:1998

Release Date

1998

Published By

German Institute for Standardization

Status

Withdraw 2008-06

Replace By

DIN EN 754-7:2008

Latest

DIN EN 754-7:2016-10

Scope

The document specifies the tolerances on dimensions and form for aluminium and aluminium alloy cold drawn seamless tubes with an outside diameter (OD) from 3 mm to 350 mm (round tube) or with a cross section contained within a circumscribing circle (CD) form 8 mm to 300 mm (other than round tube), supplied in straight lenghts. It only applies to tube produced by the seamless die/mandrel method of extrusion (and then cold drawn to be final dimensions required). It applies to cold drawn, seamless tube for general and engineering applications.

DIN EN 754-7:1998 history

• 2016 DIN EN 754-7:2016-10 Aluminium and aluminium alloys - Cold drawn rod/bar and tube - Part 7: Seamless tubes, tolerances on dimensions and form; German version EN 754-7:2016
• 2016 DIN EN 754-7:2016 Aluminium and aluminium alloys - Cold drawn rod/bar and tube - Part 7: Seamless tubes, tolerances on dimensions and form; German version EN 754-7:2016
• 2008 DIN EN 754-7:2008 Aluminium and aluminium alloys - Cold drawn rod/bar and tube - Part 7: Seamless tubes, tolerances on dimensions and form; English version of DIN EN 754-7:2008-06
• 1998 DIN EN 754-7:1998 Aluminium and aluminium alloys - Cold drawn rod/bar and tube - Part 7: Seamless tubes, tolerances on dimensions and form; German version EN 754-7:1998