This standard specifies the requirements for performance, design, materials, testing and inspection, welding, marking, handling, storage and transportation of drilling equipment used in oil and gas wells. At the same time, the working conditions of the equipment mentioned in this standard, such as pressure, temperature and fluid in the well, are also specified. This standard applies to the following equipment: a) ram blowout preventer; b) ram, ram rubber core and top seal; c) ring blowout preventer d) ring blowout preventer sealing rubber core; e) hydraulic connector ; f) Drilling spool; g) Adapter; h) Single-piece connection; i) Clamp. Dimensional interchangeability is limited to end and outlet connections. Typical equipment referred to in this standard is shown in Figures 1 and 2; see Appendix F for recommendations on failure reporting. This standard does not apply to field use and field tests of drilling equipment.
GB/T 20174-2006 Referenced Document
GB/T 228-2002 Metallic materials--Tensile testing at ambient temperature
GB/T 231.1-2002 Metallic materials--Brinell hardness test--Part 1: Test method
GB/T 2828.1-2003 Sampling procedures for inspection by attributes--Part 1: Sampling schemes indexed by acceptance quality limit(AQL) for lot-by-lot inspection
GB/T 4340.1-1999 Metallic materials--Vickers hardness test-- Part 1: Test method
GB/T 20174-2006 history
2019GB/T 20174-2019 Petroleum drilling and production equipment—Drill-through equipment
2006GB/T 20174-2006 Petroleum and natural gas industries.Drilling and production equipment.Drill-through equipment