ISO 10350-1:1998
Plastics - Acquisition and presentation of comparable single-point data - Part 1: Moulding materials
- Standard No.
- ISO 10350-1:1998
- Release Date
- 1998
- Published By
- International Organization for Standardization (ISO)
- Status
- 2007-07
- Replace By
- ISO 10350-1:2007
- Latest
- ISO 10350-1:2017
- Scope
- ISO 10350 identifies specific test procedures for the acquisition and presentation of comparable data for certain basic properties of plastics. In general, each property is specified by a single experimental value, although in certain cases properties are represented by two values obtained under different test conditions. The properties included are those presented conventionally in manufacturers' data sheets. This part of ISO 10350 applies predominantly to unreinforced and reinforced thermoplastic and thermosetting materials that may be injection- or compression-moulded or prepared as sheets of specified thickness. Part 2 deals specifically with long- or continuous-fibre-reinforced plastics. For the purposes of ISO 10350, long-fibre-reinforced plastics are considered to have fibre lengths greater than 7,5 mm prior to moulding.
ISO 10350-1:1998 history
- 2017 ISO 10350-1:2017 Plastics - Acquisition and presentation of comparable single-point data - Part 1: Moulding materials
- 2014 ISO 10350-1:2007/Amd 1:2014 Plastics - Acquisition and presentation of comparable single-point data - Part 1: Moulding materials; Amendment 1
- 2007 ISO 10350-1:2007 Plastics - Acquisition and presentation of comparable single-point data - Part 1: Moulding materials
- 1998 ISO 10350-1:1998 Plastics - Acquisition and presentation of comparable single-point data - Part 1: Moulding materials
