ASTM A1010/A1010M-13(2018) PDF

Scope: 1.1 This specification covers martensitic stainless steels for various structural, architectural, pressure vessel, and heatresisting applications. The mechanical properties of these steels are customarily, but not necessarily, developed by a suitable heat treatment generally referred to as tempering. 1.2 Steel products under this specification are available in two grades: Grade Yield Strength, min, ksi [MPa] 40 [275] 40 [275] 50 [345] 50 [345] 1.3 The maximum thickness of plates is limited only by the capacity of the composition to meet the specified mechanical property requirements; however, current practice normally limits the maximum thickness of plates furnished under this specification to 2 in. [50 mm]. 1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM A1010/A1010M-13(2018) Referenced Document

ASTM A480/A480M Standard Specification for General Requirements for Flat-Rolled Stainless and Heat-Resisting Steel Plate, Sheet, and Strip
ASTM A673/A673M Standard Specification for Sampling Procedure for Impact Testing of Structural Steel
ASTM E527 Standard Practice for Numbering Metals and Alloys (UNS)
SAE J1086 Numbering Metals and Alloys

2024 ASTM A1010/A1010M-24 Standard Specification for Higher-Strength Martensitic Stainless Steel Plate, Sheet, and Strip
2018 ASTM A1010/A1010M-13(2018) Standard Specification for Higher-Strength Martensitic Stainless Steel Plate, Sheet, and Strip
2013 ASTM A1010/A1010M-13 Standard Specification for Higher-Strength Martensitic Stainless Steel Plate, Sheet, and Strip
2001 ASTM A1010/A1010M-01(2009) Standard Specification for Higher-Strength Martensitic Stainless Steel Plate, Sheet , and Strip
2001 ASTM A1010/A1010M-01e1 Standard Specification for Higher-Strength Martensitic Stainless Steel Plate, Sheet , and Strip
2001 ASTM A1010-01 Standard Specification for Higher-Strength Martensitic Stainless Steel Plate, Sheet , and Strip