1.1 This test method is designed to determine the limiting oxygen concentration of a combustible dust dispersed in a mixture of air with an inert/nonflammable gas in a nearspherical closed vessel of 20 L or greater volume.
1.2 Data obtained from this method provide a relative measure of the deflagration characteristics of dust clouds.
1.3 This test method should be used to measure and describe the properties of materials in response to heat and flame under controlled laboratory conditions and should not be used to describe or appraise the fire hazard or fire risk of materials, products, or assemblies under actual fire conditions. However, results of this test may be used as elements of a fire risk assessment that takes into account all of the factors that are pertinent to an assessment of the fire hazard of a particular end use.
1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. Specific precautionary statements are given in Section 8.
1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
ASTM E2931-13(2019) Referenced Document
ASTM D3173 Standard Test Method for Moisture in the Analysis Sample of Coal and Coke
ASTM D3175 Standard Test Method for Volatile Matter in the Analysis Sample of Coal and Coke
ASTM E1226 Standard Test Method for Explosibility of Dust Clouds
ASTM E1515 Standard Test Method for Minimum Explosible Concentration of Combustible Dusts
ASTM E177 Standard Practice for Use of the Terms Precision and Bias in ASTM Test Methods
ASTM E2079 Standard Test Methods for Limiting Oxygen (Oxidant) Concentration in Gases and Vapors
ASTM E691 Standard Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method
ASTM E2931-13(2019) history
2019ASTM E2931-13(2019) Standard Test Method for Limiting Oxygen (Oxidant) Concentration of Combustible Dust Clouds
2013ASTM E2931-13 Standard Test Method for Limiting Oxygen (Oxidant) Concentration of Combustible Dust Clouds