ASTM A529/A529M-19 PDF

Scope: 1.1 This specification covers carbon-manganese steel shapes, plates, and bars of structural quality for use in riveted, bolted, or welded construction of buildings and for general structural purposes. 1.2 Material under this specification is available in two grades: Grade Yield Strength, ksi [MPa] Thickness 50 [345] 50 [345] Plates to 1 in. [25 mm] thick to 15 in. [380 mm] wide Bars to 31⁄2 in. [90 mm] Shapes with flange or leg thickness to 11⁄2 in. [40 mm] inclusive 55 [380] 55 [380] Plates to 1 in. [25 mm] thick to 15 in. [380 mm] wide Bars to 3 in. [75 mm] Shapes with flange or leg thickness to 11⁄2 in. [40 mm] inclusive 1.3 When the steel is to be welded, it is presupposed that a welding procedure suitable for the grade of steel and intended use or service will be utilized. See Appendix X3 of Specification A6/A6M for information on weldability. 1.4 The values stated in either inch-pound units or SI units are to be regarded as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM A529/A529M-19 Referenced Document

ASTM A6/A6M Standard Specification for General Requirements for Rolled Structural Steel Bars, Plates, Shapes, and Sheet Piling*， 2024-03-01 Update

2019 ASTM A529/A529M-19 Standard Specification for High-Strength Carbon-Manganese Steel of Structural Quality
2014 ASTM A529/A529M-14 Standard Specification for High-Strength Carbon-Manganese Steel of Structural Quality
2005 ASTM A529/A529M-05(2009) Standard Specification for High-Strength Carbon-Manganese Steel of Structural Quality
2005 ASTM A529/A529M-05 Standard Specification for High-Strength Carbon-Manganese Steel of Structural Quality
2004 ASTM A529/A529M-04 Standard Specification for High-Strength Carbon-Manganese Steel of Structural Quality
2003 ASTM A529/A529M-03 Standard Specification for High-Strength Carbon-Manganese Steel of Structural Quality
2002 ASTM A529/A529M-02 Standard Specification for High-Strength Carbon-Manganese Steel of Structural Quality
2001 ASTM A529/A529M-01 Standard Specification for High-Strength Carbon-Manganese Steel of Structural Quality
2000 ASTM A529/A529M-00 Standard Specification for High-Strength Carbon-Manganese Steel of Structural Quality
1975 ASTM A529-75 Standard Specification for Structural Steel With 42 000 Psi (290 Mpa) Minimum Yield Point (1/2 In. (12.7 Mm) Maximum Thickness)