1.1 This practice establishes the minimum requirements for radiographic examination of metallic and nonmetallic materials and components used in designated applications such as gas turbine engines and flight structures.
1.2 The requirements in this practice are intended to control the radiographic process to ensure the quality of radiographic images produced for use in designated applications such as gas turbine engines and flight structures; this practice is not intended to establish acceptance criteria for material or components. When examination is performed in accordance with this practice, engineering drawings, specifications, or other applicable documents shall indicate the acceptance criteria.
1.3 All areas of this practice may be open to agreement between the cognizant engineering organization and the supplier, or specific direction from the cognizant engineering organization.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
ASTM E2104-22 Referenced Document
ANSI/AWS A2.4 Standard Symbols for Welding@ Brazing@ and Nondestructive Examination (7th Edition)
ASTM E1025 Standard Practice for Design, Manufacture, and Material Grouping Classification of Hole-Type Image Quality Indicators (IQI) Used for Radiology
ASTM E1030/E1030M Standard Practice for Radiographic Examination of Metallic Castings
ASTM E1032 Standard Test Method for Radiographic Examination of Weldments
ASTM E1079 Standard Practice for Calibration of Transmission Densitometers
ASTM E1165 Standard Test Method for Measurement of Focal Spots of Industrial X-Ray Tubes by Pinhole Imaging
ASTM E1254 Standard Guide for Storage of Radiographs and Unexposed Industrial Radiographic Films
ASTM E1316 Standard Terminology for Nondestructive Examinations*, 2024-02-01 Update
ASTM E1390 Standard Guide for Illuminators Used for Viewing Industrial Radiographs
ASTM E1815 Standard Test Method for Classification of Film Systems for Industrial Radiography
ASTM E1817 Standard Practice for Controlling Quality of Radiological Examination by Using Representative Quality Indicators (RQIs)
ASTM E2033 Standard Practice for Computed Radiology (Photostimulable Luminescence Method)
ASTM E2698 Standard Practice for Radiographic Examination Using Digital Detector Arrays
ASTM E543 Standard Practice for Agencies Performing Nondestructive Testing
ASTM E747 Standard Practice for Design, Manufacture and Material Grouping Classification of Wire Image Quality Indicators (IQI) Used for Radiology
ASTM E999 Standard Guide for Controlling the Quality of Industrial Radiographic Film Processing
NAS410 NAS CERTIFICATION & QUALIFICATION OF NONDESTRUCTIVE TEST PERSONNEL (Rev 4)
ASTM E2104-22 history
2022ASTM E2104-22 Standard Practice for Radiographic Examination of Advanced Aero and Turbine Materials and Components
2015ASTM E2104-15 Standard Practice for Radiographic Examination of Advanced Aero and Turbine Materials and Components
2009ASTM E2104-09 Standard Practice for Radiographic Examination of Advanced Aero and Turbine Materials and Components
2001ASTM E2104-01 Standard Practice for Radiographic Examination of Advanced Aero and Turbine Materials and Components