ASTM F3240-19e1 PDF

Scope: 1.1 This practice covers the requirements for the installation of seamless molded hydrophilic gaskets (SMHG) in cured-inplace pipe (CIPP) rehabilitation of main and lateral pipelines. 1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.3 There is no similar or equivalent ISO Standard. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM F3240-19e1 Referenced Document

ASTM D1149 Standard Test Method for Rubber Deterioration-Surface Ozone Cracking in a Chamber
ASTM D1600 Standard Terminology for Abbreviated Terms Relating to Plastics
ASTM D2240 Standard Test Method for Properties of Rubber &8212; Durometer Hardness*， 2024-04-21 Update
ASTM F1216 Standard Practice for Rehabilitation of Existing Pipelines and Conduits by the Inversion and Curing of a Resin-Impregnated Tube
ASTM F1743 Standard Practice for Rehabilitation of Existing Pipelines and Conduits by Pulled-in-Place Installation of Cured-in-Place Thermosetting Resin Pipe (CIPP)
ASTM F2019 Standard Practice for Rehabilitation of Existing Pipelines and Conduits by the Pulled in Place Installation of Glass Reinforced Plastic Cured-in-Place (GRP-CIPP) Using the UV-Light Curing Method*， 2022-11-15 Update
ASTM F2561 Standard Practice for Rehabilitation of a Sewer Service Lateral and Its Connection to the Main Using a One Piece Main and Lateral Cured-in-Place Liner*， 2020-03-01 Update
ASTM F2599 Standard Practice for Sectional Repair of Damaged Pipe By Means of an Inverted Cured-In-Place Liner*， 2022-11-15 Update
ASTM F412 Standard Terminology Relating to Plastic Piping Systems*， 2023-07-20 Update
ISO/IEC 17025 General requirements for the competence of testing and calibration laboratories [Standard in French]

2023 ASTM F3240-19(2023) Standard Practice for Installation of Seamless Molded Hydrophilic Gaskets (SMHG) for Long-Term Watertightness of Cured-in-Place Rehabilitation of Main and Lateral Pipelines
2019 ASTM F3240-19e1 Standard Practice for Installation of Seamless Molded Hydrophilic Gaskets (SMHG) for Long-Term Watertightness of Cured-in-Place Rehabilitation of Main and Lateral Pipelines
2019 ASTM F3240-19 Standard Practice for Installation of Seamless Molded Hydrophilic Gaskets (SMHG) for Long-Term Watertightness of Cured-in-Place Rehabilitation of Main and Lateral Pipelines
2017 ASTM F3240-17 Standard Practice for Installation of Seamless Molded Hydrophilic Gaskets (SMHG) for Long-Term Watertightness of Cured-in-Place Rehabilitation of Main and Lateral Pipelines