This part of EN 1559 specifies the additional technical delivery conditions for castings (see EN 1753) and cast anodes (see EN 12438) made from magnesium alloys. This part of EN 1559 applies to magnesium alloy castings produced in sand or permanent moulds or by pressure die casting, centrifugal casting, continuous casting or investment casting. This part of EN 1559 does not apply to ingots, bars, billets (or other shapes) for further reprocessing, such as re-melting or extrusion.
EN 1559-5:2017 Referenced Document
EN 12438:1998 Magnesium and Magnesium Alloys - Magnesium Alloys for Cast Anodes
EN 1370:2011 Founding - Examination of surface condition*， 2024-04-20 Update
EN 1371-1:2011 Founding - Liquid penetrant testing - Part 1: Sand, gravity die and low pressure die castings*， 2024-04-20 Update
EN 1371-2:2015 Founding - Liquid penetrant testing - Part 2: Investment castings
EN 1559-1:2011 Founding - Technical conditions of delivery - Part 1: General
EN 1753:1997 Magnesium and magnesium alloys - Magnesium alloy ingots and castings
EN 1754:2015 Magnesium and magnesium alloys - Designation system for anodes@ ingots and castings - Material symbols and material numbers
EN ISO 3452-1:2013 Non-destructive testing - Penetrant testing - Part 1: General principles
EN ISO 5579:2013 Non-destructive testing - Radiographic testing of metallic materials using film and X- or gamma rays - Basic rules*， 2024-04-20 Update
EN 1559-5:2017 history
2017EN 1559-5:2017 Founding - Technical conditions of delivery - Part 5: Additional requirements for magnesium alloy castings
1997EN 1559-5:1997 Founding - Technical Conditions of Delivery - Part 5: Additional Requirements for Magnesium Alloy Castings