ASTM D1613-17
Standard Test Method for Acidity in Volatile Solvents and Chemical Intermediates Used in Paint, Varnish, Lacquer, and Related Products

Standard No.
ASTM D1613-17
Release Date
2017
Published By
American Society for Testing and Materials (ASTM)
Status
Replace By
ASTM D1613-17(2023)
Latest
ASTM D1613-17(2023)
Scope

4.1 This test method is useful for determining low levels of acidity, below 0.058201;%, in organic compounds and hydrocarbon mixtures. The total acidity is calculated as acetic acid or milligrams of sodium hydroxide per gram of sample.

4.2 Acidity may be present as a result of contamination, decomposition during storage or distribution, or manufacture. This test method may be used in assessing compliance with a specification.

1.1 This test method covers the determination of total acidity as acetic acid, in concentrations below 0.058201;%, in organic compounds and hydrocarbon mixtures used in paint, varnish, and lacquer solvents and diluents. It is known to be applicable to such mixtures as low molecular weight saturated and unsaturated alcohols, ketones, ethers, esters, hydrocarbon diluents, naphtha, and other light distillate petroleum fractions.

1.2 For purposes of determining conformance of an observed value or a calculated value using this test method to relevant specifications, test result(s) shall be rounded off “to the nearest unit” in the last right-hand digit used in expressing the specification limit, in accordance with the rounding-off method of Practice E29.

1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.4 For specific hazard information and guidance consult supplier’s Safety Data Sheet.

1.5 This standard does not purport to address the safety concerns, if any, associated with its use. It is the responsibility of whoever uses this standard to consult and establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

ASTM D1613-17 Referenced Document

  • ASTM D1193 Standard Specification for Reagent Water
  • ASTM D4806 Standard Specification for Denatured Fuel Ethanol for Blending with Gasolines for Use as Automotive Spark-Ignition Engine Fuel
  • ASTM D770 Standard Specification for Isopropyl Alcohol
  • ASTM D7795 Standard Test Method for Acidity in Ethanol and Ethanol Blends by Titration
  • ASTM E200 Standard Practice for Preparation, Standardization, and Storage of Standard and Reagent Solutions for Chemical Analysis
  • ASTM E29 Standard Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications

ASTM D1613-17 history

  • 1970 ASTM D1613-17(2023) Standard Test Method for Acidity in Volatile Solvents and Chemical Intermediates Used in Paint, Varnish, Lacquer, and Related Products
  • 2017 ASTM D1613-17 Standard Test Method for Acidity in Volatile Solvents and Chemical Intermediates Used in Paint, Varnish, Lacquer, and Related Products
  • 2006 ASTM D1613-06(2012) Standard Test Method for Acidity in Volatile Solvents and Chemical Intermediates Used in Paint, Varnish, Lacquer, and Related Products
  • 2006 ASTM D1613-06 Standard Test Method for Acidity in Volatile Solvents and Chemical Intermediates Used in Paint, Varnish, Lacquer, and Related Products
  • 2003 ASTM D1613-03 Standard Test Method for Acidity in Volatile Solvents and Chemical Intermediates Used in Paint, Varnish, Lacquer, and Related Products
  • 2002 ASTM D1613-02 Standard Test Method for Acidity in Volatile Solvents and Chemical Intermediates Used in Paint, Varnish, Lacquer, and Related Products
  • 1996 ASTM D1613-96(1999) Standard Test Method for Acidity in Volatile Solvents and Chemical Intermediates Used in Paint, Varnish, Lacquer, and Related Products
Standard Test Method for Acidity in Volatile Solvents and Chemical Intermediates Used   in Paint,     Varnish, Lacquer, and Related Products



Copyright ©2024 All Rights Reserved