This standard specifies electrical and related mechanical safety requirements for design and construction of the electrical installation in battery powered industrial trucks hereinafter referred to as trucks, with nominal voltages of the truck system up to 240 V. The Annex A is normative and gives requirements for "Connectors for traction batteries". Annex B is normative and contains "Electric motors - Output and test rules" and Annex C is normative and contains "Electromagnetic contactors". NOTE 1 Reference is made to this standard in other standards which cover the non-electrical requirements of the various industrial truck types. NOTE 2 This standard does not address the subject of charging of traction batteries (CENELEC TC 21X is preparing safety standards for battery charging). NOTE 3 The special requirements for operation in potentially explosive atmospheres are not covered in this European Standard. The requirements of this standard are applicable, when trucks are operated under the following climatic conditions: Average ambient temperature for continuous duty: +25°C; Maximum ambient temperature, short term (up to 1 h): +40°C; Lowest ambient temperature for trucks intended for use in normal indoor conditions: +5 °C; Lowest ambient temperature for trucks intended for use in normal outdoor conditions: -20 °C; Altitude: up to 2000 m; Relative humidity: in the range 30 % to 95 % (non condensing). This standard covers specific hazards (listed in clause 4), which could occur during the intended use of trucks. For hazards occurring during construction, transportation, commissioning, decommissioning and disposal, reference should be made to EN ISO 12100-2:2003.
EN 1175-1:1998+A1:2010 Referenced Document
EN 1050:1996 Safety of Machinery - Principles for Risk Assessment
EN 12895:2000 Industrial Trucks - Electromagnetic Compatibility
EN 563:1994 Safety of Machinery - Temperatures of Touchable Surfaces - Ergonomics Data to Establish Temperature Limit Values for Hot Surfaces (Incorporates Amendment A1: 1999)
EN 60034-1:1995 Rotating Electrical Machines - Part 1: Rating and Performance (Incorporates Amendment A1: 1996; Incorporating Corrigendum April 1995)
EN 60204-1:1992 Safety of machinery; electrical equipment of machines; part 1: general requirements (IEC 204-1:1992, modified)
EN 60529:1991 Degrees of Protection Provided by Enclosures (IP Code) (Incorporates Amendments A1: 2000 and A2: 2013)
EN 60947-3:1992 Low-voltage switchgear and controlgear; part 3: switches, disconnectors, switch-disconnectors and fuse-combination units (IEC 947-3:1990, modified + Corrigendum December 1991)
EN 60947-5-1:1991 Low-voltage switchgear and controlgear; part 5: control circuit devices and switching elements; section 1: electromechanical control circuit devices (IEC 947-5-1:1990)
EN ISO 12100-1:2003 Safety of machinery - Basic concepts, general principles for design - Part 1: Basic terminology, methodology Incorporates Amendment A1: 2009 [Superseded: CEN EN 292-1]*， 2024-04-20 Update
EN ISO 12100-2:2003 Safety of machinery - Basic concepts, general principles for design - Part 2: Technical principles Incorporates Amendment A1: 2009 [Superseded: CEN EN 292-2]*， 2024-04-20 Update
EN ISO 13849-1:2008 Safety of machinery - Safety-related parts of control systems - Part 1: General principles for design
EN 1175-1:1998+A1:2010 history
2010EN 1175-1:1998+A1:2010 Safety of industrial trucks - Electrical requirements - Part 1: General requirements for battery powered trucks
1998EN 1175-1:1998 Safety of industrial trucks - Electrical requirements - Part 1: General requirements for battery powered trucks (Incorporates Amendment A1: 2010)