EN ISO 16012:2015
Plastics - Determination of linear dimensions of test specimens (ISO 16012:2015)

Standard No.

EN ISO 16012:2015

Release Date

2015

Published By

European Committee for Standardization (CEN)

Latest

EN ISO 16012:2015

Replace

FprEN ISO 16012:2015

Scope

This International Standard specifies measuring instruments and methods for determining the linear dimensions of hard plastic test specimens. This standard is applicable to test specimens described in ISO 20753; However, it can also be applied to other test specimens and to thicknesses that are typically in the range 0.4 mm h 6.4 mm. NOTE Determination of dimensions of test specimens made of semi-hard materials (70 MPa

EN ISO 16012:2015 Referenced Document

• ISO 13102:2012 Geometrical product specifications (GPS) - Dimensional measuring equipment: Electronic digital-indicator gauge - Design and metrological characteristics
• ISO 13385-1:2011 Geometrical product specifications (GPS) - Dimensional measuring equipment - Part 1: Callipers; Design and metrological characteristics
• ISO 20753:2008 Plastics - Test specimens
• ISO 23529:2010 Rubber - General procedures for preparing and conditioning test pieces for physical test methods
• ISO 291:2008 Plastics - Standard atmospheres for conditioning and testing
• ISO 3611:2010 Geometrical product specifications (GPS) - Dimensional measuring equipment: Micrometers for external measurements - Design and metrological characteristics
• ISO 3650:1998 Geometrical Product Specifications (GPS) - Length standards - Gauge blocks
• ISO 463:2006 Geometrical Product Specifications (GPS) - Dimensional measuring equipment - Design and metrological characteristics of mechanical dial gauges
• ISO 9493:2010 Geometrical product specifications (GPS) - Dimensional measuring equipment: Dial test indicators (lever type) - Design and metrological characteristics

EN ISO 16012:2015 history

• 2015 EN ISO 16012:2015 Plastics - Determination of linear dimensions of test specimens (ISO 16012:2015)