IEC 61400-13:2015
Wind turbines - Part 13: Measurement of mechanical loads

Standard No.
IEC 61400-13:2015
Release Date
2015
Published By
International Electrotechnical Commission (IEC)
Status
Replace By
IEC 61400-13:2021
Latest
IEC 61400-13:2015/AMD1:2021
Replace
IEC 88/511/CDV:2015 IEC/TS 61400-13:2001
Scope
This part of the IEC 61400 describes the measurement of fundamental structural loads on wind turbines for the purpose of the load simulation model validation. The standard prescribes the requirements and recommendations for site selection, signal selection, data acquisition, calibration, data verification, measurement load cases, capture matrix, post-processing, uncertainty determination and reporting. Informative annexes are also provided to improve understanding of testing methods. The methods described in this document can also be used for mechanical loads measurements for other purposes such as obtaining a measured statistical representation of loads, direct measurements of the design loads, safety and function testing, or measurement of component loads. If these methods are used for an alternative objective or used for an unconventional wind turbine design, the required signals, measurement load cases, capture matrix, and post processing methods should be evaluated and if needed adjusted to fit the objective. These methods are intended for onshore electricity-generating, horizontal-axis wind turbines (HAWTs) with rotor swept areas of larger than 200 m2. However, the methods described may be applicable to other wind turbines (for example, small wind turbines, ducted wind turbines, vertical axis wind turbines).

IEC 61400-13:2015 Referenced Document

  • IEC 60050 International Electrotechnical Vocabulary (IEV) - Index
  • IEC 60050-101:1998 International Electrotechnical Vocabulary - Part 101: Mathematics
  • IEC 60050-102:2007 International Electrotechnical Vocabulary - Part 102: Mathematics - General concepts and linear algebra
  • IEC 60050-103:2009 International Electrotechnical Vocabulary - Part 103: Mathematics - Functions
  • IEC 60050-111:1996 International Electrotechnical Vocabulary - Chapter 111: Physics and chemistry
  • IEC 60050-112:2010 Vocabulaire Electrotechnique International – Partie 112: Grandeurs et unités (Edition 1.0)
  • IEC 60050-113:2011 International Electrotechnical Vocabulary - Part 113: Physics for electrotechnology
  • IEC 60050-114:2014 International electrotechnical vocabulary - Part 114: Electrochemistry
  • IEC 60050-121:1998 International Electrotechnical Vocabulary - Part 121: Electromagnetism
  • IEC 60050-55:1970 International Electrotechnical Vocabulary. Part 55 : Telegraphy and telephony

IEC 61400-13:2015 history




Copyright ©2024 All Rights Reserved