International Organization for Standardization (ISO)
Latest
ISO 11298-3:2018
Scope
This document, in conjunction with ISO 11298-1, specifies requirements and test methods for close-fit lining systems intended to be used for the renovation of water supply networks, which transport water intended for human consumption, including raw water intake pipelines.
It applies to pipes and fittings, as manufactured, as well as to the installed lining system. It is applicable to polyethylene (PE) pipes of either solid wall single layer or co-extruded layer construction, which is reduced in the factory or on site to provide a close-fitting independent or interactive pressure pipe liner, as well as associated fittings and joints for the construction of the lining system. It is not applicable to PE coated pipes having a peelable, contiguous, thermoplastic additional layer on the outside of the pipe.
It is applicable to PE pipes, fittings and assemblies intended to be used at an operating temperature of 20 °C as the reference temperature.
NOTE For applications operating at constant temperatures greater than 20 °C and up to 40 °C, see
ISO 11298-3:2018 Referenced Document
EN 12201-1:2011 Plastics piping systems for water supply, and for drainage and sewerage under pressure - Polyethylene (PE) - Part 1: General
EN 12201-2:2011 Plastics piping systems for water supply, and for drainage and sewerage under pressure - Polyethylene (PE) - Part 2: Pipes (Incorporates Amendment A1: 2013)
EN 12201-4:2012 Plastics piping systems for water supply, and for drainage and sewerage under pressure - Polyethylene (PE) - Part 4: Valves
EN 12201-5:2011 Plastics piping systems for water supply, and for drainage and sewerage under pressure - Polyethylene (PE) - Part 5: Fitness for purpose of the system
ISO 11298-1:2018 Plastics piping systems for renovation of underground water supply networks - Part 1: General
ISO 12176-1:2017 Plastics pipes and fittings — Equipment for fusion jointing polyethylene systems — Part 1: Butt fusion
ISO 12176-2:2008 Plastics pipes and fittings - Equipment for fusion jointing polyethylene systems - Part 2: Electrofusion
ISO 3126:2005 Plastics piping systems - Plastics components - Determination of dimensions
ISO 4427-1:2007 Plastics piping systems - Polyethylene (PE) pipes and fittings for water supply - Part 1: General
ISO 4427-2:2007 Plastics piping systems - Polyethylene (PE) pipes and fittings for water supply - Part 2: Pipes
ISO 4427-3:2007 Plastics piping systems - Polyethylene (PE) pipes and fittings for water supply - Part 3: Fittings
ISO 4427-5:2007 Plastics piping systems - Polyethylene (PE) pipes and fittings for water supply - Part 5: Fitness for purpose of the system
ISO 11298-3:2018 history
2018ISO 11298-3:2018 Plastics piping systems for renovation of underground water supply networks - Part 3: Lining with close-fit pipes
2010ISO 11298-3:2010 Plastics piping systems for renovation of underground water supply networks - Part 3: Lining with close-fit pipes