ISO 286-2:1988
ISO system of limits and fits; part 2: tables of standard tolerance grades and limit deviations for holes and shafts

Standard No.

ISO 286-2:1988

Release Date

1988

Published By

International Organization for Standardization (ISO)

Status

Withdraw

Replace By

ISO 286-2:1988/Cor 1:2006

Latest

ISO 286-2:2010/cor 1:2013

Scope

This part gives of the limit deviations for commonly used tolerance classes calculated from the information given in ISO 286-1. It covers values for the upper and the lower deviations which are illustrated by a figure. It tabulates numerical values for basic sizes from 3 mm up to and including 3150 mm. An annex gives a graphical review of tolerance zones.

ISO 286-2:1988 history

• 2013 ISO 286-2:2010/cor 1:2013 Geometrical product specifications (GPS) - ISO code system for tolerances on linear sizes - Part 2: Tables of standard tolerance classes and limit deviations for holes and shafts; Technical Corrigendum 1
• 2010 ISO 286-2:2010 Geometrical product specifications (GPS) - ISO code system for tolerances on linear sizes - Part 2: Tables of standard tolerance classes and limit deviations for holes and shafts
• 2006 ISO 286-2:1988/Cor 1:2006 ISO system of limits and fits - Part 2: Tables of standard tolerance grades and limit deviations for holes and shafts; Technical Corrigendum 1
• 1988 ISO 286-2:1988 ISO system of limits and fits; part 2: tables of standard tolerance grades and limit deviations for holes and shafts