ASTM D4321-15 PDF

Scope: 4.1 Actual yield is important to the film converter as this determines the actual number of units or packages that he can derive in a particular conversion from any given mass of film.

1.1 This test method covers the determination of yield (area per unit mass) of plastic film.

1.2 Also described in this test method is the means for calculating nominal yield, given values for nominal density, and nominal thickness. This is needed since, in material specifications, limits for yield are normally stated in terms of the percent deviation of actual yield from nominal yield.

1.3 The values stated in SI units are to be regarded as the standard. The values given in brackets are for information only.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 1: This standard and ISO8201;4591 address the same subject matter, but differ in technical content.

ASTM D4321-15 Referenced Document

ASTM D1505 Standard Test Method for Density of Plastics by the Density-Gradient Technique
ASTM D4883 Standard Test Method for Density of Polyethylene by the Ultrasound Technique
ASTM D6988 Standard Guide for Determination of Thickness of Plastic Film Test Specimens
ASTM D792 Standard Test Methods for Density and Specific Gravity (Relative Density) of Plastics by Displacement
ASTM D883 Standard Terminology Relating to Plastics
ASTM E691 Standard Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method