This European Standard specifies the requirements for factory made products of expanded cork, which are used for the thermal insulation of buildings. The products are made with granulated cork agglomerated without additional binders and are delivered as boards with or without facings or coatings. Products covered by this standard are also used in prefabricated thermal insulation systems and composite panels; the performance of systems incorporating these products is not covered. This standard describes product characteristics and includes procedures for testing, evaluation of conformity, marking and labelling. This standard does not specify the required level of a given property to be achieved by a product to demonstrate fitness for purpose in a particular application. The levels required for a given application are to be found in regulations or non-conflicting standards. Products with a declared thermal resistance lower than 0,25 m2K/W, or a declared thermal conductivity greater than 0,060 W/(mK), at 10 °C, are not covered by this European Standard.
EN 13170:2012+A1:2015 Referenced Document
EN 12086:2013 Thermal insulating products for building applications - Determination of water vapour transmission properties
EN 12089:2013 Thermal insulating products for building applications - Determination of bending behaviour
EN 12090:2013 Thermal insulating products for building applications - Determination of shear behaviour
EN 12105:1998 Resilient floor coverings - Determination of moisture content of agglomerated composition cork
EN 12430:2013 Thermal insulating products for building applications - Determination of behaviour under point load
EN 12431:2013 Thermal insulating products for building applications - Determination of thickness for floating floor insulating products
EN 1602:2013 Thermal insulating products for building applications - Determination of the apparent density
EN 1603:2013 Thermal insulating products for building applications - Determination of dimensional stability under constant normal laboratory conditions (23 �� 50 % relative humidity)
EN 1604:2013 Thermal insulating products for building applications - Determination of dimensional stability under specified temperature and humidity conditions
EN 1605:2013 Thermal insulating products for building applications - Determination of deformation under specified compressive load and temperature conditions
EN 1606:2013 Thermal insulating products for building applications - Determination of compressive creep
EN 1607:2013 Thermal insulating products for building applications - Determination of tensile strength perpendicular to faces
EN 1609:2013 Thermal insulating products for building applications - Determination of short term water absorption by partial immersion
EN 1991-1-1:2002 Eurocode 1: Actions on structures - Part 1-1: General actions - Densities, self-weight and imposed loads for buildings
EN 822:2013 Thermal insulating products for building applications - Determination of length and width
EN 823:2013 Thermal insulating products for building applications - Determination of thickness
EN 824:2013 Thermal insulating products for building applications - Determination of squareness
EN 825:2013 Thermal insulating products for building applications - Determination of flatness
EN 826:2013 Thermal insulating products for building applications - Determination of compression behaviour
EN 13170:2012+A1:2015 history
2018EN 13170:2012/PRA2:2018 Thermal insulation products for buildings - Factory made products of expanded cork (ICB) - Specification
2015EN 13170:2012+A1:2015 Thermal insulation products for buildings - Factory made products of expanded cork (ICB) - Specification
2012EN 13170:2012 Thermal insulation products for buildings - Factory made products of expanded cork (ICB) - Specification (Incorporates Amendment A1: 2015)
2008EN 13170:2008 Thermal insulation products for buildings - Factory made products of expanded cork (ICB) - Specification
2001EN 13170:2001 Thermal Insulation Products for Buildings - Factory Made Products of Expanded Cork (ICB) - Specification Including Corrigendum December 2005