This European Standard specifies: - the dimensional, leaktightness, mechanical and hydraulic characteristics with which shower hoses should comply; - the procedures for testing these characteristics. This European Standard applies to shower hoses of any material used for ablutionary purposes and intended for equipping and supplementing sanitary tapware for baths and showers. This European Standard applies to shower hoses connected downstream of the obturator of the tapware. Hoses which are an integral part of sanitary tapware (sink and wash basin mixing valves) or hoses intended to connect sanitary tapware to the water supplies are not covered by this European Standard. Details of pressures and temperatures are given in Table 1.
EN 1113:2015 Referenced Document
EN 1112:2008 Sanitary tapware - Shower outlets for sanitary tapware for water supply systems of type 1 and type 2 - General technical specification [Superseded: CEN EN 13904]
EN 248:2002 Sanitary tapware - General specification for electrodeposited coatings of Ni-Cr*， 2024-04-20 Update
EN ISO 228-1:2003 Pipe threads where pressure-tight joints are not made on the threads - Part 1: Dimensions, tolerances and designation ISO 228-1: 2000
EN 1113:2015 history
2015EN 1113:2015 Sanitary tapware - Shower hoses for sanitary tapware for water supply systems of type 1 and type 2 - General technical specification
2008EN 1113:2008 Sanitary tapware - Shower hoses for sanitary tapware for water supply systems of type 1 and type 2 - General technical specification [Superseded: CEN EN 13905]
1997EN 1113:1997 Showers Hoses for (PN 10) Sanitary Tapware